Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Injectors
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Injector catalogue › Petrol › Port | Direct | Diesel

Petrol injectors are organised here by where the nozzle delivers fuel. Port injectors meter fuel into the intake; gasoline direct injectors deliver it into the combustion chamber. Some engines use both. Identify the complete part, not only its connector or colour.

For how the ECU operates these injectors, see port injector flow, dead time and driver compatibility and port injection modes and timing. Petrol direct injection and combustion modes covers the direct-injection system separately.

Nozzle and spray matching

An electrically controlled port injector meters fuel through a valve and nozzle as its driver commands it. The resulting spray depends on the nozzle and its installation, not only the injector’s rated flow. Bosch describes how the number and position of the nozzle orifices and the injector’s orientation are selected for a particular intake and mixture formation. Bosch: manifold fuel injector.

For example, Bosch Motorsport lists conical and two-spray versions of its EV 14 family, with different spray and bend angles. Its EV 14 product data and datasheet define the angles and orientation for that family. Equal flow and a matching connector do not establish equivalent targeting, fit, electrical drive or calibration. Check the exact part and installation against its supplier’s information.

During a bench test compare the pattern with the specification or a known-good example at the same pressure, fluid and drive conditions. An asymmetrical spray may be intentional; droplets, missing streams or leakage need investigation in context. Injector test results explains how to record the conditions.

Browse the catalogue

A Deka VII petrol fuel injector
Deka VII port-injector example; the photograph is illustrative and is not identified as any particular entry below. Photo: David DeGrace via Wikimedia Commons, CC BY-SA 3.0; unchanged.
BMW petrol direct-injection cutaway with an injector in the cylinder head
BMW direct-injection engine cutaway, showing the injector directed into the combustion chamber; illustration only, not a part-number identification. Photo: Ton1 via Wikimedia Commons, CC BY-SA 3.0; unchanged.

Comparing ratings

A port injector's cc/min figure needs a test liquid, temperature and pressure difference to be meaningful. Static flow does not define the electrical offset or short-pulse delivery needed by the ECU. Direct-injection parts need their own high-pressure and pulse-specific test conditions. Bosch's injection-valve information explains static-flow pressure conversion and voltage-dependent delay; Bosch's HDEV 5.2 datasheet illustrates the separate GDI operating conditions.

See also: Automotive fuel injector testers and noid lights for electrical signal checks, injector testing methods and equipment examples.