Tuning Wiki

MaxxECU V1 — Discontinued first-generation MaxxECU, superseded by RACE according to the manufacturer. MaxxECU product information.

MaxxECU V1
MaxxECU V1, manufacturer product image: MaxxECU. Used with permission.

Model identification and capabilities

V1 has eight peak-and-hold injector outputs and eight ignition outputs, supporting up to eight sequential cylinders or twelve with wasted spark. The manufacturer lists eight EGT inputs, built-in wideband and a 400 kPa MAP sensor. Rev 6 raised injector output capability; Rev 7 added logging and digital-input changes; Rev 9 added LSU 4.9 support. Manufacturer specification; MaxxECU model comparison.

Sequential cylinders, maximum8
Injector outputs8 peak-and-hold
Ignition outputs8
ConfigurationMTune; check the release appropriate to the ECU and hardware revision

Identification and installation

The V1 wiring archive includes separate REV5+ and REV9+ documents. Identify the actual hardware revision before choosing a connector diagram or wideband sensor; do not assume a RACE replacement has identical wiring.

Record the model label, serial number, hardware revision, firmware, connector keying and loom. Outputs can be assigned or share functions; supported functions also depend on available I/O and software configuration. The figure in the comparison is a controller capability, not proof of compatibility with a particular engine or vehicle.

Connector and pinout

Complete 48-way connector 1 positions from the manufacturer’s model-specific column. A dash in the source is shown as not assigned. Consult the drawing for orientation and the remaining connectors. Exact wiring and connector reference.

PositionManufacturer functionNotes
A1GPO 5
A2IGN 1
A3IGN 2
A4GPO 8/TACHO660ohm pullup
B1GPO 6
B2IGN 3
B3IGN 4
B4GPO 1
C1GPO 7
C2IGN 5
C3IGN 6
C4GPO 2
D1WBO2 Heater-
D2IGN 7
D3IGN 8
D4GPO 3
E1CAN H
E2CAN L
E3GND Shield
E4GPO 4
F1CLT
F2IAT
F3WBO2 VREF
F4WBO2 VS
G1+5V sensor supply(peak 0.5A, max 150mA)
G2TPS/AIN
G3WBO2 IP
G4WBO2 RCAL
H1Sensor GND
H2Trigger GND
H3TRIGGER
H4HOME
J1AIN 1 (Temperature)
J2AIN 2 (Temperature)
J3AIN 3 (0-5V)
J4AIN 4 (0-5V)
K1INJ 1
K2INJ 2
K3DIN/VR 1
K4DIN/VR 2
L1INJ 8
L2INJ 7
L3INJ 6
L4Engine GND
M1INJ 3
M2INJ 4
M3INJ 5
M4+12V ECU power supply

Consult the full diagram for wiring, grounds, supply fuses, driver limits, connector orientation and remaining positions. Sensor grounds and power grounds have different purposes; follow the matching manual.

Software and further documents

Sources reviewed 17 November 2026.

Directly applicable articles

Technical articles assigned to this context will appear here.