Tuning Wiki

Link G3 LEM is a documented G3 Link engine-management designation. Link identifies a 26-way connector kit specifically for G3 LEM and states it does not fit the G3 LinkPlus. PCLink 3.40 is listed for G2/G3 firmware 1.9.2 or earlier. Identification source.

Identification and software

Record the complete model and revision label, board identifiers, installed firmware, connector configuration and any adapter loom. Similar Link model names occur in later generations. Use the manufacturer's legacy PCLink compatibility table and seek Link support if the appropriate package is unclear.

Model-specific wiring

The identified manufacturer documentation or legacy manual archive is the starting point for this model. An individual pin-by-pin allocation was not verified in this reference; obtain the exact matching manual and connector orientation before wiring.

See Link standalone ECUs for related models and generation distinctions.

G3 LEM wiring and firmware evidence

In a Link support discussion about a particular LEM G3 upgraded to G4 firmware, Link staff confirmed pin 26 as the sensor ground in that installation. They also stated that G3 “Load Input 3” becomes “An Volt 3” after that upgrade, and the physical G3 analogue voltage inputs 1 and 2 become An Volt 4 and 5. These are model- and firmware-specific observations, not a complete 26-position schedule; confirm board, orientation, firmware and all remaining connections with Link.

Directly applicable articles

Technical articles assigned to this context will appear here.

Continue the conversation

If this topic interests you, consider joining the following forums. They host material referenced in this article.