
MS3Pro Mini is a MegaSquirt-family engine-management product. Compact 35-way AMPSEAL ECU with eight saturated injector outputs, four logic-level ignition outputs, built-in 4-bar MAP and separate barometric sensor, according to its manual. Model source.
Identification and software
Record the ECU label, processor generation, board revision, firmware and installed hardware modifications. Calibration software and firmware must match the hardware. DIYAutoTune software and firmware · Model-specific information.
Wiring and pinout
MS3Pro Mini AMPSEAL connector
Positions below follow the manufacturer connector decal and Mini manual. Verify physical orientation against the manufacturer drawing and note that MicroSquirt uses a different assignment despite the similar connector. Output H can be used as a tachometer with the documented pull-up configuration.
| Pin | Function |
|---|---|
| 1 | 12 V switched input |
| 2 | +5 V VREF output |
| 3 | PWM output 1 / idle |
| 4 | Fuel pump output |
| 5 | Injector A |
| 6 | Injector B |
| 7 | Injector C |
| 8 | Injector D |
| 9 | Injector E |
| 10 | Injector F |
| 11 | Injector G |
| 12 | Injector H |
| 13 | Analogue input 1 |
| 14 | Analogue input 2 |
| 15 | Analogue input 3 |
| 16 | Analogue input 4 |
| 17 | Spark output A |
| 18 | Spark output B |
| 19 | Spark output C |
| 20 | Spark output D |
| 21 | Sensor ground |
| 22 | Power ground |
| 23 | Power ground |
| 24 | CAN low |
| 25 | CAN high |
| 26 | Coolant temperature input |
| 27 | Intake air temperature input |
| 28 | Throttle position input |
| 29 | Digital switched input 1 / flex fuel |
| 30 | Crank sensor + |
| 31 | Crank sensor − |
| 32 | Cam sensor + |
| 33 | Cam sensor − |
| 34 | Digital frequency input 1 |
| 35 | Digital frequency input 2 |
Use the matching model document and wiring or support reference; the manufacturer manual index distinguishes wire-in and vehicle-specific variants. Check connector orientation, wiring changes, fuse ratings and output configuration before connecting loads; matching cases or software families do not establish identical pin functions.
See the MegaSquirt and MS3Pro family guide. Sources reviewed 17 November 2026.