Tuning Wiki
Electromotive TEC-II eight-cylinder controller
TEC-II eight-cylinder model. Image: Electromotive TEC installation manual, page 6; reproduced with permission.

Electromotive TEC-II is a model in the Total Engine Control family. Earlier TEC engine and ignition control unit; the manufacturer groups its installation and calibration manual with TEC-1. Manufacturer source.

Identification and software

Identify the exact model, serial, firmware and ignition-driver configuration before using a calibration or connecting a loom. WinTEC versions and hardware vary; the Electromotive manual archive separates the generations.

Wiring and pinout

Consult the model-specific manufacturer source and technical archive for the matching connector, firing order, ECU earths, injector drivers and ignition connections. Do not transfer TECgt200 or TECs200 positions to earlier TEC units. Where a complete exact-model pinout has not been verified, use the manufacturer documentation and verify the actual part number.

Availability

As of 17 November 2026, the manufacturer states it is not selling or repairing products. Electromotive notice. See the Electromotive family reference.

Documented injector and auxiliary connections

Electromotive’s TEC-I / TEC-II installation manual describes these connections for the four- and six-cylinder TEC-II. This is a partial schedule, not a complete ECU pinout. Pin numbers repeat across different connector groups: identify the group and hardware version before wiring. The eight-cylinder version uses a separate five-pin injector connector.

Four- and six-cylinder injector outputs

PinFunction
11Injector 1 (coil A group)
12Injector 2 (coil C group); not used on standard four-cylinder configuration
13Injector 3 (coil B group)
14Injector common +12 V

Idle air control connections described in Honda TEC-II supplement

PinFunctionExample IAC wire
1ISMARed
2ISMBBlack
3ISMCGreen
4ISMDWhite

Communications terminals described in the supplement

PinFunction
12GND
13TXD
14RXD

Directly applicable articles

Technical articles assigned to this context will appear here.