Tuning Wiki
FT400 ECU
FT400 product image from the FuelTech manufacturer manual, page 5; reproduced with permission.

FuelTech FT400 is a Earlier FT generation engine-management unit. Early colour-touchscreen ECU with two injection banks, seven auxiliary outputs and electronic-throttle support, according to the shared manual. FuelTech model documentation · FuelTech range comparison.

Identification and software

Record the exact model, serial, harness, firmware and configured outputs; similarly named FT models may use different connectors and functions. Tuning software: ECU Manager / Datalogger. FuelTech software and compatibility.

Wiring and pinout

Use the model-specific manual and the current FuelTech manuals index for connector view, cavity numbering, fuse values, sensor grounds and injector-driver limits. The manufacturer wiring archive contains installation-specific examples; match the exact ECU and harness before wiring. Pin functions depend on the model, hardware and configured output.

See FuelTech engine-management family for other models and company background. FuelTech is based in Brazil and has a US operation in Georgia. Sources reviewed 17 November 2026.

24-way main harness connector

Functions are from the FuelTech FT350 / FT400 manual, version 2.0, section 5.1. The source shows the rear of the harness connector. Inputs 2 and 4 have variant-specific recommended applications; check the model and configuration. Ground requirements in this manual differ from other FT generations.

PinFunction
1Tachometer output (green)
2Auxiliary output #3 (yellow 3)
3Input 1 — intake air temperature (white/blue)
4Auxiliary output #2 (yellow 2)
5Input 2 — configurable sensor (white)
6Auxiliary output #1 (yellow 1)
7Input 3 — coolant temperature (pink)
8Auxiliary output #4 (yellow 4)
9Input 4 — configurable sensor (blue)
10Ignition output E (gray E)
11TPS signal / TPS 1 on electronic throttle (orange)
12Ignition output D (gray D)
13MAP signal output (yellow/red)
14Ignition output C (gray C)
15Camshaft position sensor input (green/yellow)
16Ignition output B (gray B)
17RPM signal input (shielded cable)
18Ignition output A (gray A)
19Battery negative / signal ground (black)
205 V sensor supply (green/red)
21Switched 12 V supply (red)
22Power ground (black/white)
23Fuel injector bank B negative (brown)
24Fuel injector bank A negative (purple)

FT400 16-way auxiliary connector

Section 5.2 applies this connector to FT400 only. The manufacturer's table repeats “auxiliary #7” for pins 4, 6 and 8, although the harness diagram labels them #7, #6 and #5 respectively. Confirm these outputs and wiring with FuelTech; the table also disagrees with the diagram on the #1/#2 suffixes of the paired motor wire colours, while agreeing on their motor function.

PinFunction
1O2 sensor input
2Ignition output F
3Electronic throttle TPS 2
4Auxiliary output #7 (yellow #7)
5Two-step input
6Yellow #6 auxiliary output — table calls it #7; see note
7A/C button input
8Yellow #5 auxiliary output — table calls it #7; see note
9Power ground
10Pedal signal #1
11Throttle or pedal sensor ground output
12Pedal signal #2
13Electronic throttle motor #1 / step motor coil #1
14Electronic throttle motor #2 / step motor coil #2
15Electronic throttle motor #1 / step motor coil #1
16Electronic throttle motor #2 / step motor coil #2

Directly applicable articles

Technical articles assigned to this context will appear here.

Shared family guidance

From parent families. Broader context does not establish compatibility with this ECU or software version.