
Four-cylinder fuel and ignition ECU with two injector and two coil outputs, arranged for semi-sequential injection and wasted spark. DTAFast T2 product information.
Features and application
DTAFast lists closed-loop wideband lambda, launch, closed-loop flat shift and VTEC; its product description excludes variable camshaft control and traction control. All T-series units use the T-Series PC software; DTAFast describes configurable inputs and outputs, integrated Bosch wideband measurement, logging, firmware updates and a built-in trigger oscilloscope. Available functions and channel limits depend on the exact model and firmware. Manufacturer specification.
Identification and wiring
Identify the printed model including any “+” or “i” suffix, hardware revision, connector and firmware before allocating pins. Configurable functions may differ from defaults. Manufacturer T2 wiring diagram and connector pinout contains connector orientation, cavity functions, power, earth and sensor examples. Follow its fuse and load requirements; do not interchange pin numbering with another T-series controller.
T2 34-way connector — diagram version 1.03
This is the pin-insertion side of the T2 harness connector, not T2i or T4. The functions below follow DTAFast's six-page T2 diagram; configurable I/O assignments and hardware revision notes are in that document. Separate fused permanent and ignition feeds are shown.
| Pin | Function | Pin | Function |
|---|---|---|---|
| 1 | PWM 1 | 18 | PWM 3 |
| 2 | Lambda Nernst voltage | 19 | Crank |
| 3 | Coil 1 | 20 | Analogue 1 |
| 4 | Lambda VGND | 21 | Permanent 12 V |
| 5 | Lambda pump current | 22 | Analogue 2 |
| 6 | Coil 2 | 23 | Analogue 3 |
| 7 | Lambda trim resistor | 24 | Thermistor 1 |
| 8 | Injector 1 | 25 | Analogue 4 |
| 9 | Injector 2 | 26 | PWM 4 |
| 10 | PWM 2 | 27 | 5 V out |
| 11 | Digital 1 | 28 | Sensor ground |
| 12 | Wheel 1 | 29 | Sensor ground |
| 13 | Power ground 1 | 30 | Digital 2 |
| 14 | Power ground 2 | 31 | Ignition 12 V input |
| 15 | Lambda heater negative | 32 | Thermistor 2 |
| 16 | CAN high | 33 | Analogue 5 |
| 17 | CAN low | 34 | Analogue 6 |
Software and related information
DTAFast provides model-specific wiring diagrams, firmware, manuals and PC software via its downloads section. Capture the existing calibration and firmware identifiers before making changes. See the DTAFast family overview for earlier S and E series models.