Earlier MicroSquirt V2; DIYAutoTune lists it as a legacy unsupported ECU. Do not use V3 or MS3Pro Mini connector assignments without matching documentation. DIYAutoTune product and support information.
Identification and wiring
Record exact model, board revision, firmware, installation and carrier before wiring. DIYAutoTune documentation index includes model-specific manuals; connector functions are not interchangeable across ECU and module designs. Confirm all power, grounds and driver ratings from the applicable manual.
See MegaSquirt and MS3Pro family. Sources reviewed 17 November 2026.
35-way AMPSEAL connector
Functions below follow the MicroSquirt V2 wiring guide. The earlier pre-V3 guide labels pin 21 as ground; V3 assigns this pin to VR2−. Older units and harnesses may be modified, so confirm revision and actual wiring with the manufacturer. See its connector view, electrical limits and related input guidance before wiring; supported assignments can depend on firmware and hardware modifications.
| Pin | Function in guide |
|---|---|
| 1 | 12 Volt Supply |
| 2 | CAN High |
| 3 | CAN Low |
| 4 | VRIN2+ |
| 5 | Spare Input |
| 6 | Flex Fuel |
| 7 | FIDLE |
| 8 | FUEL PUMP |
| 9 | INJECTOR 1 |
| 10 | INJECTOR 2 |
| 11 | IGNITION OUTPUT #2 |
| 12 | IGNITION OUTPUT #1 |
| 13 | SERIAL Rx |
| 14 | SERIAL Tx |
| 15 | BOOTLOADER |
| 16 | ACCEL LED |
| 17 | WARM-UP LED |
| 18 | N/C (ground) |
| 19 | SERIAL GROUND |
| 20 | SENSOR GROUND |
| 21 | GROUND |
| 22 | GROUND |
| 23 | GROUND |
| 24 | MAP |
| 25 | CLT |
| 26 | IAT |
| 27 | TPS |
| 28 | Vref |
| 29 | SPARE ADC |
| 30 | OPTOIN+ |
| 31 | OPTOIN- |
| 32 | VRIN1+ |
| 33 | VRIN- |
| 34 | O2 |
| 35 | TACH OUTPUT |