Tuning Wiki

MicroTech LTX-8 is a standalone or earlier programmable engine-management system. Historical LTX-8 model recorded in an Australian workshop equipment list; verify the specific ECU and loom. Model-specific information.

Identification and features

Record the ECU label, model, part number, hardware revision, firmware, configured injectors, ignition hardware and loom before comparing systems. Some outputs can be reassigned; hardware, software, current limits and engine-specific options determine what is actually available.

Wiring and pinout

Consult the MicroTech LTX-8 wiring and documentation source and identify the exact connector face, part and version. Do not apply wiring from a similarly named model. If an exact drawing is unavailable for the unit at hand, obtain it from the manufacturer or supplier before making connections.

Further information

Manufacturer harness reference

MicroTech's MT/LT Series installation manual, version 2.1, February 2002, specifically lists LTX8 among the fuel-and-ignition systems. This table covers the wire functions described in that manual; it is not a complete connector cavity schedule. The exact ignition and auxiliary assignments depend on the ECU and engine-specific diagram.

Harness wireDocumented function
Heavy redBattery positive through fuse
Heavy blackBattery negative
PinkIgnition-switched +12 V sensing
GreenFuel-pump relay control
VioletCoolant-temperature sensor signal
Thin blackAir-temperature sensor signal
BrownSensor ground
BlueTPS +5 V for variable-resistor sensor
GreyTPS signal
Black/redOxygen-sensor input
WhiteAuxiliary connection, function depends on system
Grey/blue, grey/black, grey/red, grey/white, grey/greenIgnition and tachometer signals; assignments and use vary by application
Shielded multicore cableCrank-angle sensor or electronic distributor; refer to exact system drawing

Ignition distinction: the manual says not to connect the white wire of fuel-and-ignition MT8/LT8, MTX8/LTX8 or MTX12/LTX12 units to coil negative. The white-wire instructions for fuel-only systems do not apply to these models. Check the appropriate engine-specific drawing.

Directly applicable articles

Technical articles assigned to this context will appear here.