Tuning Wiki

The original Dropbear V1 is an eight-injector, eight-ignition-output Speeduino ECU based on Teensy 3.5. The project guide describes its logic pre-drivers, two 24-way connectors, internal VR conditioning and CAN. Outputs and software assignments depend on configuration.

Black 24-way connector

From the project Dropbear connector guide. Consult its connector face view, fusing, electrical ratings and switches.

PinFunction
A1Switched 12 V
A2Power ground
A35 V sensor reference
A4Not used
A5Spare digital input 2
A6CAN L
A7CAN H
A8Power ground
B1Tachometer
B2Crank primary
B3Crank negative (VR only)
B4Cam primary
B5Cam negative (VR only)
B6Spare digital input 1
B7Clutch input (ground switching)
B8Flex sensor
C1Analog sensor ground
C2Spare analog input 1
C3Spare analog input 2
C4Oxygen sensor input
C5Coolant sensor
C6Intake air sensor
C7Throttle position
C8External MAP input

Grey 24-way connector

PinFunction
A1Injector 1
A2Injector 2
A3Injector 3
A4Injector 4
A5Injector 5
A6Injector 6
A7Injector 7
A8Injector 8
B1Ignition 1
B2Ignition 2
B3Ignition 3
B4Ignition 4
B5Ignition 5
B6Ignition 6
B7Ignition 7
B8Ignition 8
C1Boost
C2Fan relay
C3Spare 2 / stepper B2
C4Idle / stepper B1
C5VVT / stepper A1
C6Spare 1 / idle 2 / stepper A2
C7Fuel pump relay
C8Power ground

Generation-specific software pin numbers

The harness terminal names above are the same in the project guide. TunerStudio pin identifiers differ between generations, so select the actual hardware. Source: Speeduino Dropbear documentation.

Black terminalFunctionV1 software pinV2 software pin
A5Spare digital 22234
B6Spare digital 12335
C2Spare analogue 1A17A16
C3Spare analogue 2A18A17

See the Dropbear family page and Speeduino index.

Directly applicable articles

Technical articles assigned to this context will appear here.

Shared family guidance

From parent families. Broader context does not establish compatibility with this ECU or software version.