
The manufacturer catalogue specifies the drive-by-wire Lotus 2ZZ-GE plug-in. Manual v2.0 is for EMU Black software 2.169 or later and documents naturally aspirated and supercharged variants, OEM CAN, variable valve lift and timing, and a stock 2ZZ base map. Actual installation depends on the engine and car specification. Model source · ECUMaster plug-in catalogue.
Wiring and pinout
The manual's page 8 describes wideband signal connections at the OEM Lotus connector. The following are the ECU terminal labels, not sensor connector pin numbers. The source gives separate Bosch LSU 4.2 and 4.9 sensor-side mappings and instructs disconnection of the OEM narrowband sensor when fitting wideband. Manufacturer model-specific document.
| Terminal | Documented function |
|---|---|
| 3K | Wideband heater |
| 4E | Wideband Ip |
| 3A | Wideband Vs |
| 3D | Wideband Rcal |
| 4F | Wideband VGnd |
| 3G | +12 V |
Spare factory terminals — manual v2.0
The manufacturer's spare-I/O table lists these positions on otherwise unused OEM ECU terminals. This is not a complete factory connector pinout.
| ECU terminal | Manual function |
|---|---|
| 1G | EGT input 1 |
| 2C | RS232 TX |
| 3C | RS232 RX |
| 3D | Wideband Rcal |
| 3F | EGT input 2 |
| 4E | Wideband Ip |
| 4F | Wideband VGnd |
| 3A | Knock sensor input 2 (source conflicts; see below) |
| 3L | Flex fuel input |
Conflicting source: The same manual assigns terminal 3A to wideband Vs in its wideband wiring table and knock sensor input 2 in the spare-I/O table. Confirm the correct assignment with ECUMaster for the specific ECU before wiring.
Wideband connector mapping
Sensor-side terminals differ between LSU 4.2 and 4.9. The manual directs that the original narrowband sensor be disconnected before installing a wideband.
| ECU terminal | Function | LSU 4.2 terminal | LSU 4.9 terminal |
|---|---|---|---|
| 3K | Heater | 4 | 3 |
| 4E | Ip | 6 | 1 |
| 3A | Vs (conflicts with spare-I/O table) | 1 | 6 |
| 3D | Rcal | 2 | 5 |
| 4F | VGnd | 5 | 2 |
| 3G | +12 V | 3 | 4 |
Calibration and fitment checks
Record the engine code, ECU label and hardware, factory wiring and software version. The manufacturer provides software, available application notes and base maps; a base map is a starting point requiring checks of sensor readings, throttle operation, injector and ignition settings, trigger timing and engine calibration. Do not transfer universal EMU Black pin numbers or another plug-in's auxiliary connector assignments to this unit.
See the EMU Black model page and manufacturer index.
Other 2ZZ arrangements
The ECU manual lists separate CAN dashboard settings for 2ZZ electronic throttle, cable throttle and Lotus S3 2ZZ; a selectable software mode alone does not prove that one physical plug-in ECU fits every harness. RRR separately sells a Lotus S2 2ZZ cable-throttle adapter kit using an EMU Black. Identify the kit and adapter maker and obtain the matching wiring instructions; it is not established to be the same integrated ECU as the ECUMaster DBW plug-in.