Tuning Wiki

Adaptronic M1200 is a standalone or earlier programmable engine-management system. Modular M1200 universal wire-in ECU; Haltech retains a model-specific startup guide, pinout and basemap. Its 26-way connector diagram identifies four injectors; high-impedance injectors are specified in that diagram. Model-specific information.

Identification and features

Record the ECU label, model, part number, hardware revision, firmware, configured injectors, ignition hardware and loom before comparing systems. Some outputs can be reassigned; hardware, software, current limits and engine-specific options determine what is actually available.

Wiring and pinout

Consult the Adaptronic M1200 wiring and documentation source and identify the exact connector face, part and version. Do not apply wiring from a similarly named model. If an exact drawing is unavailable for the unit at hand, obtain it from the manufacturer or supplier before making connections.

Further information

Manufacturer connector pinouts

Transcribed from the Adaptronic M1200 wiring diagrams in Haltech's archive. The source marks optional functions in red; optionality is noted below. The drawing says pins 1A, 2I and 2S must not be connected. The 26-way injector outputs are specified for high-impedance injectors, 2 A maximum. The diagrams require external ignition drivers or coils with built-in igniters; see the source for wiring orientation, wire colours, current limits, power supplies and ECU configuration.

22-way connector

PinFunction in drawing
1ADo not connect
1BIgnition +12 V
1CServo (optional)
1DAuxiliary 2
1EAuxiliary 5
1FIgnition 3
1GIgnition 1
1HIgnition 2
1ICAN low (optional)
1JAuxiliary 3
1KCAN high (optional)
1LAuxiliary 6
1MVehicle speed sensor
1NFuel pressure (optional)
1ODigital input 3 (optional)
1PDigital input 1 (optional)
1QDigital input 2 (optional)
1RAuxiliary 7
1SDigital input 4 (optional)
1TIgnition 4
1UTPS 2 (optional)
1VFuel temperature (optional)

26-way connector

PinFunction in drawing
2APower ground
2BPower ground
2CSensor ground
2DSensor ground
2ECAS 1
2FCAS 3 (optional)
2GCAS 2 (optional)
2HOil temperature (optional)
2IDo not connect
2JKnock (optional)
2K5 V sensor supply
2LOil pressure (optional)
2MThrottle position
2NOxygen 1 (optional)
2OIMAP / external MAP input (optional)
2PManifold air temperature
2QCoolant temperature
2RTachometer (optional)
2SDo not connect
2TECCS / EFI / fuel pump relay output
2UInjector 1
2VInjector 4
2WAuxiliary 1
2XAuxiliary 4
2YInjector 2
2ZInjector 3

Directly applicable articles