
Model and vehicle application
Syvecs lists this vehicle-specific standalone or plug-in ECU kit as Can-Am Maverick X3 2021-2023, with product code S7Plus-CanAmDF21. The product page and its stated vehicle, model and transmission details define this particular application; confirm market, model year, engine, ECU connector and transmission against Syvecs before ordering.
This entry describes the dedicated vehicle kit. It is distinct from the generic wire-in ECU: a plug-in kit can use application-specific adaptor wiring, a carrier, additional modules and an application calibration. The listed hardware or supported equipment can vary by revision.
Wiring and pinout
Syvecs Can-Am Maverick X3 2021-2023 installation and wiring document. Follow the connector orientation, application-specific tables, installation notes and hardware revision in this document. Do not transfer assignments from another vehicle merely because the underlying ECU family is similar. The link was checked to return a PDF.
For other variants and manual revisions consult the manufacturer's vehicle-specific manual index. Available spare inputs and outputs can be used only within their electrical limits and with a matching calibration.
Calibration and service
Use the correct Syvecs software, firmware and base calibration for the exact vehicle and installed hardware. The Syvecs software portal and firmware archive provide manufacturer support. A base map is a starting point and needs checking against the actual engine, injectors, sensors and modifications.
Sources
- Syvecs Can-Am Maverick X3 2021-2023 product listing and application
- Manufacturer kit installation and pinout manual
- Syvecs plug-in kit support index
Additional I/O connector
The Syvecs 2021–2023 Can-Am installation manual, page 7, documents the following 26-way connector on the rear of the ECU. Pins 18–19 default to CAN3 according to the guide; verify the exact configuration and connector orientation before wiring. This is the additional I/O connector, not a complete factory vehicle connector pinout.
| Pin | Function |
|---|---|
| 1 | Ground |
| 2 | HBR5 |
| 3 | HBR6 |
| 4 | Fuel 8 |
| 5 | Fuel 7 |
| 6 | Fuel 6 |
| 7 | Vbat |
| 8 | Lambda 1 heater |
| 9 | Lambda 1 A |
| 10 | Lambda 1 B |
| 11 | Lambda 1 D |
| 12 | RS232 RX |
| 13 | RS232 TX |
| 14 | AN12 |
| 15 | AN13 |
| 16 | HBR3 |
| 17 | +5 V |
| 18 | EGT− / CAN3 L |
| 19 | EGT+ / CAN3 H |
| 20 | Analogue ground |
| 21 | CAN2 H |
| 22 | CAN2 L |
| 23 | LAN RX− |
| 24 | LAN RX+ |
| 25 | LAN TX− |
| 26 | LAN TX+ |