Tuning Wiki

Link G2 LinkPlus is a documented G2 Link engine-management designation. Link's technical forum archive identifies a LinkPlus G2 wiring and installation manual; the manufacturer legacy software page associates G2 with PCLink 3.40. Identification source.

Identification and software

Record the complete model and revision label, board identifiers, installed firmware, connector configuration and any adapter loom. Similar Link model names occur in later generations. Use the manufacturer's legacy PCLink compatibility table and seek Link support if the appropriate package is unclear.

Model-specific wiring

The identified manufacturer documentation or legacy manual archive is the starting point for this model. An individual pin-by-pin allocation was not verified in this reference; obtain the exact matching manual and connector orientation before wiring.

See Link standalone ECUs for related models and generation distinctions.

Generation and firing sequence

Link staff distinguish G2 from G1 LinkPlus wiring: G2 channel numbering follows injector numbering while G1 uses firing sequence. Confirm the exact ECU and loom configuration before transferring any connections between generations.

Directly applicable articles

Technical articles assigned to this context will appear here.

Continue the conversation

If this topic interests you, consider joining the following forums. They host material referenced in this article.