MoTeC M4, part 11001, is an earlier Gold Box engine controller listed in MoTeC's obsolete-product archive. The manufacturer manual describes four injector groups and gives examples for six-, eight- and twelve-cylinder engines using injectors wired in groups; this is not a claim of separate sequential outputs for each cylinder. Manufacturer Gold Box archive; manufacturer model glossary.
Identification and compatibility
Read the full ECU part number, connector, firmware, options and the label before identifying the correct model. Configurations and optional engine packages vary; a similar suffix, physical plug or a common calibration does not establish a universal pinout or exact cylinder capability. The manufacturer's archived product listing provides M4-specific documentation.
Pinout and software
Consult the MoTeC M4 product and wiring downloads and MoTeC legacy downloads. Model and marine-labelled variants must be checked against their own part numbers, connector drawings and firmware. Confirm connector orientation and the complete power, ground, sensor, injector and ignition circuits with the original documentation before wiring.
These units use a legacy ECU Manager or EMP software generation appropriate to the exact controller and firmware; M1 Tune is for M1 products. See MoTeC software archive and the MoTeC manufacturer guide.
Manufacturer wiring diagram pinout
Transcribed from the M4 ECU wiring drawing on printed page 55 of the MoTeC M4/M48/M8 user manual. The model-specific drawing and ECU connector view define the orientation. Shared ignition and auxiliary or digital-input functions depend on the configuration. Pins described only by the PC connector connection are identified that way; do not assume their signalling standard. Check hardware revision, electrical loads and trigger wiring against the original.
36-way connector
| Pin | Function in manufacturer drawing |
|---|---|
| 1 | Battery positive |
| 2 | Injector 1 |
| 3 | Injector 2 |
| 4 | Sensor 5 V |
| 5 | REF Hall / optical |
| 6 | REF magnetic |
| 7 | SYNC Hall / optical |
| 8 | SYNC magnetic |
| 9 | PC/calibrator D9 pin 6 |
| 10 | PC/calibrator D9 pin 9 |
| 11 | PC/calibrator D9 pin 5 |
| 12 | PC/calibrator D9 pin 7 |
| 13 | Auxiliary 1 |
| 14 | Injector 3 |
| 15 | Injector 4 |
| 16 | Throttle position |
| 17 | Manifold pressure |
| 18 | Auxiliary voltage |
| 19 | Digital input 1 |
| 20 | Digital input 2 |
| 21 | PC/calibrator D9 pin 2 |
| 22 | PC/calibrator D9 pin 3 |
| 23 | PC/calibrator D9 pin 4 |
| 24 | PC/calibrator D9 pin 1 |
| 25 | ECU power ground |
| 26 | Sensor 8 V |
| 27 | Sensor 0 V |
| 28 | Engine temperature |
| 29 | Air temperature |
| 30 | Auxiliary temperature |
| 31 | Lambda + |
| 32 | Lambda − |
| 33 | Ignition 1 |
| 34 | Auxiliary 2 / ignition 2 |
| 35 | Auxiliary 3 / ignition 3 |
| 36 | Auxiliary 4 / ignition 4 |