Tuning Wiki

DTAFast E4 is a historic programmable engine-management identity documented in the manufacturer's model wiring schematic. The 14 February 1997 DTA four-cylinder power schematic shows two ignition coil outputs, injector output, switched supply and separate battery earth connections.

Identification

Identify the actual case label, harness connectors, output configuration and firmware. An old loom may have been modified for a particular engine. No current product availability or universal support status is inferred from this historical schematic.

Model-specific pinout and wiring

The manufacturer E4 drawing supplies connector views, functions, sensor/actuator examples and grounding. The separate E4/E6/E8 sensor schematic must be used alongside the power schematic. Both battery earth connections are called out in the period power drawing. Match connectors and diagram orientation to the actual ECU; do not transfer pin assignments from another E- or S-series model.

Power connector assignments in the 1997 drawing

The following positions are traced from the DTAFast E4 power schematic dated 14 February 1997, which labels the view as the female loom power connector. “Not shown” means the drawing does not identify a connection; it does not establish that a cavity is unused in every build. Connect both specified power grounds and use the manufacturer diagram and correct fuses and relay arrangements.

PinFunction shown
AIgnition-switched supply
BBattery negative / ground
CBattery negative / ground
DCoil 1, earth side
ECoil 2, earth side
FInjector bank 1
GNot shown in this power schematic
HNot shown in this power schematic
JNot shown in this power schematic
KGear-change light, 20 W maximum
LNot shown in this power schematic
MNot shown in this power schematic
NTachometer output
PNot shown in this power schematic
RNot shown in this power schematic
SNot shown in this power schematic
TNot shown in this power schematic
UNot shown in this power schematic

Separate sensor connector

The DTAFast E4/E6/E8 sensor schematic dated 14 February 1997 depicts a separate male connector on the loom. The table follows the terminal connections drawn for the listed sensor examples, not the separate female power connector. “No connected function shown” is not a claim that the cavity is unused in every ECU. Use the source’s connector view and check the exact sensor and loom.

Sensor connector pinConnection in the DTAFast drawing
AShift-cut switch terminal 2
BShift-cut switch terminal 1
CThrottle potentiometer high side (throttle open)
DThrottle potentiometer wiper
EThrottle potentiometer opposite end
FWater-temperature sensor terminal 1
GWater-temperature sensor terminal 2
HAir-temperature sensor terminal 1
JAir-temperature sensor terminal 2
KPressure sensor terminal 3, 5 V in the Marelli example
LPressure sensor terminal 1, signal in the Marelli example
MCrank sensor terminal 1 in the depicted Ford/Vauxhall example
NCrank sensor terminal 2 / shield return in the Vauxhall example
PLambda sensor terminal 2 in the diagram
RLambda sensor terminal 1 / earthed side
SNo connected function shown
TNo connected function shown
UNo connected function shown
VPressure sensor terminal 2, earth in the Marelli example

The schematic says to use screened crank-sensor cable, with the Vauxhall sensor pin 1 to M, pin 2 to N and pin 3 shield to N. It calls for reversed Ford/Marelli crank sensor polarity and states that R connects to the earthed side of the lambda sensor. Confirm sensor terminals and electrical configuration in the original diagram.

Related documentation

DTAFast's wiring archive includes crank sensor rules and legacy ECU sheets. Confirm support, software and hardware serviceability directly with DTAFast. See the DTAFast family overview.

Directly applicable articles

Technical articles assigned to this context will appear here.