
Model and vehicle application
Syvecs lists this vehicle-specific standalone or plug-in ECU kit as Kawasaki SXR, with product code S7-KawaSXR. The product page and its stated vehicle, model and transmission details define this particular application; confirm market, model year, engine, ECU connector and transmission against Syvecs before ordering.
This entry describes the dedicated vehicle kit. It is distinct from the generic wire-in ECU: a plug-in kit can use application-specific adaptor wiring, a carrier, additional modules and an application calibration. The listed hardware or supported equipment can vary by revision.
Wiring and pinout
Syvecs Kawasaki SXR installation and wiring document. Follow the connector orientation, application-specific tables, installation notes and hardware revision in this document. Do not transfer assignments from another vehicle merely because the underlying ECU family is similar. The link was checked to return a PDF.
For other variants and manual revisions consult the manufacturer's vehicle-specific manual index. Available spare inputs and outputs can be used only within their electrical limits and with a matching calibration.
Calibration and service
Use the correct Syvecs software, firmware and base calibration for the exact vehicle and installed hardware. The Syvecs software portal and firmware archive provide manufacturer support. A base map is a starting point and needs checking against the actual engine, injectors, sensors and modifications.
Sources
- Syvecs Kawasaki SXR product listing and application
- Manufacturer kit installation and pinout manual
- Syvecs plug-in kit support index
Expansion connector
From page 8 of the Syvecs Kawasaki SXR 1500/160 plug-in guide. This covers the expansion connector only; consult the separate OEM connector diagram in that guide for the vehicle plug. In this kit the guide assigns CAN2 low to pin 21 and high to 22; other Syvecs kits can differ.
| Pin | Function |
|---|---|
| 1 | Ground |
| 2 | AN01 |
| 3 | AN02 — launch switch, pull to ground |
| 4 | AN11 |
| 5 | Knock ground |
| 6 | Knock signal |
| 7 | +5 V sensor supply |
| 8 | LamV — NTK grey |
| 9 | LamI — NTK white |
| 10 | LamGnd — NTK black |
| 11 | Fuel output 9 — NTK blue |
| 12 | Fuel output 11 |
| 13 | 12 V — NTK yellow |
| 14 | IGN3 — TTL/smart coils |
| 15 | IGN4 — TTL/smart coils |
| 16 | IGN5 — TTL/smart coils |
| 17 | IGN6 — TTL/smart coils |
| 18 | K-type − |
| 19 | K-type + |
| 20 | Analogue sensor ground |
| 21 | CAN2 L |
| 22 | CAN2 H |
| 23 | LAN RX− — orange/white |
| 24 | LAN RX+ — white/orange |
| 25 | LAN TX− — green/white |
| 26 | LAN TX+ — white/green |