
Model and vehicle application
Syvecs lists this vehicle-specific standalone or plug-in ECU kit as VAG TSI EA888, with product code SGDI-TSI-DF. The product page and its stated vehicle, model and transmission details define this particular application; confirm market, model year, engine, ECU connector and transmission against Syvecs before ordering.
This entry describes the dedicated vehicle kit. It is distinct from the generic wire-in ECU: a plug-in kit can use application-specific adaptor wiring, a carrier, additional modules and an application calibration. The listed hardware or supported equipment can vary by revision.
Wiring and pinout
Syvecs VAG TSI EA888 installation and wiring document. Follow the connector orientation, application-specific tables, installation notes and hardware revision in this document. Do not transfer assignments from another vehicle merely because the underlying ECU family is similar. The link was checked to return a PDF.
For other variants and manual revisions consult the manufacturer's vehicle-specific manual index. Available spare inputs and outputs can be used only within their electrical limits and with a matching calibration.
Calibration and service
Use the correct Syvecs software, firmware and base calibration for the exact vehicle and installed hardware. The Syvecs software portal and firmware archive provide manufacturer support. A base map is a starting point and needs checking against the actual engine, injectors, sensors and modifications.
Sources
- Syvecs VAG TSI EA888 product listing and application
- Manufacturer kit installation and pinout manual
- Syvecs plug-in kit support index
External 34-way connector
From page 5 of the Syvecs VAG TSI E888 plug-in guide, version 1.1. The guide specifies mating connector 4-1437290-0. This is the external connector, not the complete factory vehicle pinout. The guide's cover and kit description say TSI E888, although one introductory sentence says TFSI; verify the correct unit with Syvecs.
| Pin | Function |
|---|---|
| 1 | Ground |
| 2 | EGT K-type − |
| 3 | EGT K-type + |
| 4 | Fuel 7 output — port injector |
| 5 | Fuel 11 output — port injector |
| 6 | Fuel 14 output — port injector |
| 7 | Fuel 15 output — port injector |
| 8 | Spare |
| 9 | 12 V |
| 10 | +5 V |
| 11 | Analogue ground |
| 12 | AN04 input |
| 13 | AN08 input |
| 14 | AN09 input |
| 15 | AN15 input |
| 16 | AN17 input |
| 17 | AN22 input |
| 18 | RS232 RX |
| 19 | RS232 TX |
| 20 | CAN2 L |
| 21 | CAN2 H |
| 22 | CAN3 L |
| 23 | CAN3 H |
| 24 | Variable power output |
| 25 | 12 V |
| 26 | Spare |
| 27 | Fuel 8 |
| 28 | AN21 |
| 29 | H-bridge 5 |
| 30 | H-bridge 6 |
| 31 | LAN RX− |
| 32 | LAN RX+ |
| 33 | LAN TX− |
| 34 | LAN TX+ |