
Haltech Elite 950 is a Elite programmable engine-management model. The manufacturer lists an internal 3-bar MAP sensor, four ignition outputs and eight peak-and-hold injection outputs; check the actual connector allocation and configuration. It also lists two position inputs, five digital pulsed outputs, two analogue inputs and one CAN bus. Manufacturer specification or guide.
Identification and output allocation
Record the full ECU label, serial number, hardware or harness revision, software and existing calibration. These characteristics are model-specific; a superficially similar Elite ECU should not be treated as a drop-in replacement. Counts can be limited by shared outputs, external modules and the engine's ignition and injection strategy.
Model-specific pinout and wiring
Consult the Elite 950 wiring documentation and the historic model manuals and connector archive where applicable. Select the named model and the precise harness revision; read its numbered connector view, driver characteristics, injector supply, power and ground notes. The connector appearance alone is not proof of identical pin functions.
Software and further information
ESP for Elite firmware 2.xx and NSP for Elite firmware 3.xx. Haltech's download centre separates software and provides a legacy section. See Haltech standalone ECUs for the other families.
34-way connector pinout
Transcribed from the Haltech Elite 950 complete pinout. Manufacturer wire-colour abbreviations are retained; a dash means no function is shown in the source. The * symbol identifies the manufacturer's default allocation, which may be configurable. Use the original diagram for connector orientation and electrical limits.
| Pin | Wire colour code | Function |
|---|---|---|
| 1 | V/BR | DPO 2 |
| 2 | GY/Y <SHD> | AVI 1 (* O2 Sensor) |
| 3 | Y/B | IGN 1 |
| 4 | Y/R | IGN 2 |
| 5 | Y/O | IGN 3 |
| 6 | Y/G | IGN 4 |
| 7 | L/G | INJ 7 |
| 8 | L/V | INJ 8 |
| 9 | O | +5V DC |
| 10 | B | BATTERY GROUND |
| 11 | B/W | SIGNAL GROUND |
| 12 | GY <SHD> | DPI 1 |
| 13 | GY/B <SHD> | DPI 2 |
| 14 | W | THROTTLE POSITION SENSOR |
| 15 | Y | AVI 3 (* MAP ) |
| 16 | W | CAN H |
| 17 | L | CAN L |
| 18 | V/B | DPO 1 |
| 19 | L | INJ 1 |
| 20 | L/B | INJ 2 |
| 21 | L/BR | INJ 3 |
| 22 | L/R | INJ 4 |
| 23 | V/R | DPO 3 |
| 24 | B/Y | DPO 5 (* Fuel Pump Relay) |
| 25 | V/O | DPO 4 |
| 26 | R/L | +13.8V ECU / INJECTOR PWR |
| 27 | L/O | INJ 5 |
| 28 | L/Y | INJ 6 |
| 29 | GY | AIR TEMPERATURE |
| 30 | V | COOLANT TEMPERATURE |
| 31 | Y (GY 4C) | TRIGGER + |
| 32 | Y (GY/B 4C) | HOME + |
| 33 | G (GY 4C) | TRIGGER - |
| 34 | G (GY/B 4C) | HOME - |