Tuning Wiki

The 9A4 is a four-cylinder CAN-based fuel-injection ECU. SBD says its successor 9M4 uses the same pinout and instruction sheets. The 9A4 has one CAN bus, according to the SBD CAN setup guide. Source and identification.

Wiring and pinout

Model wiring documentation: J2 Delphi 36-way, issue F. Check connector view, wiring harness, ECU part number and installed calibration before connecting power. Programmable input and output functions depend on the map and software.

Configuration and support

For programmable SBD-supplied ECUs, Easimap is used to inspect and change maps, subject to the interface and access of the actual ECU. Some vehicle-manufacturer supplied units are locked; SBD’s FAQ warns against attempting downloads to locked ECUs. Do not assume that a serial ECU map or harness transfers directly to a newer CAN unit.

Evidence limits

Verify the build, trigger inputs, coil-driver type and software with the supplier. Not all historic variants and pin assignments are documented here.

J2 Delphi 36-way connector — issue F

From SBD's connector list. SBD confirms this 9A4 issue F sheet is used for the 9M4. Pin numbers identify connector cavities; consult the diagram for the view. Programmable pins depend on the installed map.

PinGeneral function
1Injector D (4th to fire)
2Water temperature
3Air temperature
45VA reference
50VA
6Power ground
7Power ground
8CAN low
9CAN high
10Permanent 12 V supply
11Crank return
12Crank signal
13Switched 12 V supply
14Injector A (1st to fire)
15Ignition D (4th to fire)
16Programmable low-side output
17Programmable low-side output
18Ignition B (2nd to fire)
19Programmable input
20Throttle position
21MAP
225VA reference
230VA
240VA
25Programmable input/output
26Injector C (3rd to fire)
27Programmable input
28Barometric pressure
29Lambda
30Cam signal
31Cam return
32Injector B (2nd to fire)
33Programmable low-side output
34Programmable low-side output
35Ignition C (3rd to fire)
36Ignition A (1st to fire)

Directly applicable articles

Technical articles assigned to this context will appear here.