Tuning Wiki
Haltech Platinum Sprint 500 ECU
Haltech Platinum Sprint 500. Image: Haltech, from its model quick-start guide, reproduced with permission.

Haltech Platinum Sprint 500 is a Platinum programmable engine-management model. The manufacturer's specification lists four injector and four ignition outputs. The injector outputs are for high-impedance injectors above 8 ohms; consult the guide for suitable ballast when appropriate. Manufacturer specification or guide.

Identification and output allocation

Record the full ECU label, serial number, hardware or harness revision, software and existing calibration. These characteristics are model-specific; a superficially similar Platinum ECU should not be treated as a drop-in replacement. Counts can be limited by shared outputs, external modules and the engine's ignition and injection strategy.

Model-specific pinout and wiring

Consult the Platinum Sprint 500 wiring documentation and the historic model manuals and connector archive where applicable. Select the named model and the precise harness revision; read its numbered connector view, driver characteristics, injector supply, power and ground notes. The connector appearance alone is not proof of identical pin functions.

Software and further information

ECU Manager for Platinum series. Haltech's download centre separates software and provides a legacy section. See Haltech standalone ECUs for the other families.

Manufacturer ECU connection table

These 32 positions are from page 16 of Haltech's Platinum Sprint 500 quick-start guide. A dash is an unspecified position in that guide. Colour abbreviations use the first colour as the main insulation and the second as the stripe; L denotes blue.

PinHarness colourConnection
1Y, 4-core greyTrigger (+)
2Y, 4-core grey/blackHome (+)
3——
4GY, shieldedRoad speed input (DPI 1)
5——
6V/BTacho output (DPO 1)
7V/BRThermofan output (DPO 2)
8V/RGeneral purpose output 1 (DPO 3)
9V/OGeneral purpose output 2 (DPO 4)
10GY/R+12 V switched
11R+12 V switched
12B/YFuel pump relay trigger
13L/RInjector 4
14L/BRInjector 3
15L/BInjector 2
16LInjector 1
17G, 4-core greyTrigger (−)
18G, 4-core grey/blackHome (−)
19——
20O/BAux rev limiter (AVI 1)
21GY/O, shieldedO2 sensor input
22B/WSignal ground
23BPower ground
24VCoolant temperature (ATI 1)
25GYAir temperature (ATI 2)
26YMAP
27WTPS
28O+5 V
29Y/GIgnition output 4
30Y/OIgnition output 3
31Y/RIgnition output 2
32Y/BIgnition output 1

The ignition outputs require suitable external ignition amplifiers or a CDI, as described in the guide. Configure functions for the actual installation and check current ratings in the manufacturer documentation.

Directly applicable articles

Technical articles assigned to this context will appear here.

Shared family guidance

From parent families. Broader context does not establish compatibility with this ECU or software version.