
Link G4X RX7S7X is a vehicle-specific programmable plug-in ECU for the Mazda RX-7 series 7 application listed in Link's model-specific manuals index. It is an application board, rather than the universal wire-in ECU. Check the exact vehicle, market, engine, original ECU and board part number against the manufacturer's RX7S7X installation manual.
Identification and installation
Record the Link model label and revision, donor factory ECU connector and car's engine and year. Plug-in boards connect to particular factory-harness layouts; the family or vehicle name alone does not establish every model-year or transmission combination. The manufacturer manual gives the supported application and any installation or configuration notes for this board.
G4X plug-in platforms offer configurable fuel and ignition control but available channels and features depend on the original header and board. The G4X plug-in general specifications are conditional on the particular application and do not mean every input is brought out to the factory harness.
Pinout and tuning
The RX7S7X installation manual is the model-specific source for board pinouts, expansion connections, electrical cautions and startup configuration. Use its connector orientation and the exact board version; do not copy a wire-in ECU pinout onto a factory harness. PCLink and manual downloads; Link manufacturer overview.
Manufacturer connector schedules
From Link's RX7S7X installation manual. Pinouts are viewed looking into the ECU from the wire side. A dash reproduces an unspecified source field; nc is Link's label. Confirm the exact board revision and vehicle harness before use.
The factory header table applies to Link’s Series 7–8 model. Expansion and CAN connections depend on bottom-board revision.
Factory main header
| Factory pin | Link ECU channel | Factory function |
|---|---|---|
| A | nc | — |
| 3S | Ground (CAS) | — |
| B | nc | — |
| 3T | An Temp 3 | IAT |
| C | Aux 2 | ISC Solenoid |
| 3U | Trig 2 | Trig 2 |
| D | nc | — |
| 3V | An Temp 1 | Fuel Temp |
| E | nc | — |
| 3W | An Temp 2 | ECT |
| F | nc | — |
| 3X | nc | — |
| G | nc | — |
| 3Z | nc | — |
| H | Injector 7 (Aux) | Air Con Fan |
| 3AB | Ground (Signal) | — |
| I | nc | — |
| K | nc | — |
| 4A | +14V (Main Relay) | ECU Power |
| L | Ground | — |
| 4B | nc (constant +12V) | — |
| M | nc | — |
| 4C | DI 6 | Start Signal |
| O | Aux 1 | Boost Solenoid |
| 4D | nc | — |
| Q | Injector 1 | Front Primary Injector |
| 4E | +14V (Main Relay) | ECU Power |
| R | nc | — |
| 4F | Injector 5 (Aux) | Fuel Pump Speed Relay |
| S | Aux 7 | Metering Oil Pump (Rotary Oil Pump) |
| 4G | Injector 6 (Aux) | Fuel Pump Relay |
| U | Injector 2 | Rear Primary Injector |
| 4H | nc | — |
| W | Aux 6 | Metering Oil Pump (Rotary Oil Pump) |
| 4I | Ignition 4 (Aux) | Air Con Clutch |
| X | Ground | — |
| 4K | Aux 3 | Engine Fan |
| Y | Injection 3 | Front Secondary Injector |
| 4L | Injector 8 (Aux) | Engine Fan (High Speed) |
| AA | Aux 8 | Metering Oil Pump (Rotary Oil Pump) |
| 4M | Aux 4 | Tacho |
| AB | Ground | — |
| 4O | nc | — |
| AC | Injector 4 | Rear Secondary Injector |
| 4P | nc | — |
| AD | nc | — |
| 4Q | DI 3 | Vehicle Speed |
| AE | Aux 5 | Metering Oil Pump (Rotary Oil Pump) |
| 4R | nc | — |
| AF | Ground | — |
| 4S | DI 4 | Clutch Switch (Some models) |
| AH | nc | — |
| 4U | nc | — |
| AJ | Ground | — |
| 4V | DI 1 | A/C Request |
| 4W | DI 2 | PS Switch |
| 3A | +5V Out | — |
| 4Y | nc | — |
| 3B | nc | — |
| 4AA | nc | — |
| 3C | nc | — |
| 4AB | nc | — |
| 3D | An Volt 1 | Oxygen Sensor Signal |
| 4AC | nc | — |
| 3E | nc | — |
| 4AE | nc | — |
| 3F | nc | — |
| 4AF | Ignition 3 | Ignition (Trailing Front) |
| 3G | nc | — |
| 4AG | DI 5 | A/C Switch |
| 3H | An Volt 3 | Metering Oil Pump Position Signal |
| 4AH | An Volt 4 | MAP Signal |
| 3I | An Volt 2 | TPS Signal |
| 4AI | nc | — |
| 3K | nc | — |
| 4AJ | Ignition 2 | Ignition (Trailing Rear) |
| 3M | nc | — |
| 4AK | nc | — |
| 3O | Knock 1 | Knock |
| 4AL | nc | — |
| 3Q | nc | — |
| 4AM | nc | — |
| 3R | Trig 1 | Trig 1 |
| 4AN | Ignition 1 | Ignition (leading) |
Expansion: bottom board V1.3 and earlier
| Position | Link ECU channel |
|---|---|
| Expansion 1 | Ground (Signal) |
| Expansion 2 | +5V Out |
| Expansion 3 | DI 8 |
| Expansion 4 | DI 7 |
| Expansion 5 | An Volt 5 |
| Expansion 6 | An Volt 6 |
| Expansion 7 | An Volt 7 |
| Expansion 8 | An Temp 4 |
| Expansion 9 | Ignition 8 |
| Expansion 10 | Ignition 7 |
| Expansion 11 | Ignition 6 |
| Expansion 12 | Ignition 5 |
| Expansion 13 | An Volt 9 |
| Expansion 14 | An Volt 8 |
| Expansion 15 | DI 10 |
| Expansion 16 | DI 9 |
Expansion: bottom board V1.4
| Position | Link ECU channel |
|---|---|
| Expansion 1 | Ground (Signal) |
| Expansion 2 | +5V Out |
| Expansion 3 | An Volt 8 |
| Expansion 4 | An Volt 7 |
| Expansion 5 | An Volt 6 |
| Expansion 6 | An Volt 5 |
| Expansion 7 | Aux 10 |
| Expansion 8 | Aux 9 |
| Expansion 9 | Ground (Signal) |
| Expansion 10 | +5V Out |
| Expansion 11 | Ignition 8 |
| Expansion 12 | Ignition 7 |
| Expansion 13 | Ignition 6 |
| Expansion 14 | Ignition 5 |
| Expansion 15 | An Volt 10 |
| Expansion 16 | An Volt 9 |
| Expansion 17 | Ground (Signal) |
| Expansion 18 | +5V Out |
| Expansion 19 | An Volt 12 |
| Expansion 20 | An Volt 11 |
| Expansion 21 | An Temp 4 |
| Expansion 22 | DI 11 |
| Expansion 23 | DI 8 |
| Expansion 24 | DI 7 |
| E-Throttle Relay | Aux 16 |
CAN 1 / RS232: V1.3 and earlier
| Pin | Function | Wire colour |
|---|---|---|
| 1 | Comms GND | Brown |
| 2 | CAN1 L | Green |
| 3 | CAN1 H | White |
| 4 | RS232-RX | Grey |
| 5 | RS232-TX | Yellow |
CAN 2 / OBD: V1.3 and earlier
| Pin | Function | Wire colour |
|---|---|---|
| 1 | GND | Brown |
| 2 | CAN2 L | Green |
| 3 | CAN2 H | White |
| 4 | NC | Grey |
| 5 | +14V | Yellow |
CAN 1 and 2: V1.4
| Pin | Function | Wire colour |
|---|---|---|
| 1 | GND | Black |
| 2 | CAN L | Green |
| 3 | CAN H | White |
| 4 | +14V | Red |