Pectel T2 is an earlier fuel-and-ignition motorsport ECU. The period Pectel product sheet describes four high-impedance injector drivers, two ignition channels, up to 10,000 rpm and a data logbook. Source.
Identification and application
Record the full label, part number, serial, hardware build, software and calibration. Engine-specific and championship looms may have different external connectors; matching the model name does not establish the complete wiring. See the Cosworth Pectel family.
Wiring and pinout evidence
AiM's Pectel T2 documentation identifies ECU pin 7 as RS232 TX, pin 18 as ground and pin 6 as 12 V for its documented connection. Its older logging manual also lists the remaining engine-control pins, and notes that ignition output type can depend on build. Use the matching unit's documentation before wiring. Source for wiring and support.
Software and data
Historic Pectel units may require earlier software and serial interfaces. Confirm the exact software and data stream version before connecting a logger, and retain the original calibration. Avoid assuming that modern Cosworth configuration tools can communicate with every historic ECU.
Documented T2 connector schedule
AiM's ECU logger connection manual, page 52, identifies these positions for the Pectel T2. The connector drawing shows 26 positions, but the text assigns only 1–25; position 26 remains unverified. Ignition output type is a build option, and the listed injectors are high-impedance only. Confirm the exact ECU and electrical limits before wiring.
T2 front connector
| Pin | Function | Notes |
|---|---|---|
| 1 | IGN1 | Build option: low-side or TTL coil driver |
| 2 | INJ1 | High-impedance injector |
| 3 | INJ3 | High-impedance injector |
| 4 | PWM1 | Low-side, 10 A maximum |
| 5 | Engine ground | — |
| 6 | +12 V | — |
| 7 | RS-232 TX | ECU transmit |
| 8 | Crank input | — |
| 9 | MAF/MAP | Analog input |
| 10 | Lambda voltage | — |
| 11 | Air temperature | Analog input |
| 12 | Sensor ground | — |
| 13 | Spare digital | Switched input |
| 14 | IGN2 | Build option: low-side or TTL coil driver |
| 15 | INJ2 | High-impedance injector |
| 16 | INJ4 | High-impedance injector |
| 17 | PWM2 | Low-side, 10 A maximum |
| 18 | Engine ground | — |
| 19 | RS-232 RX | ECU receive |
| 20 | PWM3 | Low-side, 10 A maximum |
| 21 | Cam input | — |
| 22 | TPS | Analog input |
| 23 | Coolant temperature | Analog input |
| 24 | Spare analog | Analog input |
| 25 | +5 V sensor supply | 200 mA maximum |
| 26 | Not listed in source | — |