MicroTech LT-8 is a standalone or earlier programmable engine-management system. Historical LT family model recorded by an Australian tuning workshop; exact engine-specific wiring and hardware version must be identified. Model-specific information.
Identification and features
Record the ECU label, model, part number, hardware revision, firmware, configured injectors, ignition hardware and loom before comparing systems. Some outputs can be reassigned; hardware, software, current limits and engine-specific options determine what is actually available.
Wiring and pinout
Consult the MicroTech LT-8 wiring and documentation source and identify the exact connector face, part and version. Do not apply wiring from a similarly named model. If an exact drawing is unavailable for the unit at hand, obtain it from the manufacturer or supplier before making connections.
Further information
Manufacturer 4-cylinder connector layouts
From MicroTech's LT-8 Mitsubishi/Mazda four-cylinder sequential drawing, revision 1.0 dated 4 October 2004. These tables follow the drawing's ECU view, left to right; the column index is a relative position, not a manufacturer cavity number. Engine, ignition system and loom configuration can vary, so verify the label, drawing and matching ignition sheet for the exact ECU.
6-way connector
| Relative column from left | Upper row label | Lower row label |
|---|---|---|
| 1 | IGN OUTPUT #2 | IGN OUTPUT #1 |
| 2 | IGN OUTPUT #4 | IGN OUTPUT #3 |
| 3 | IGN OUTPUT #0 / TACH OUTPUT | AUX #2 |
16-way connector
| Relative column from left | Upper row label | Lower row label |
|---|---|---|
| 1 | AUX OUTPUT | AUX INPUT |
| 2 | INJ OUT #1 | FUEL PUMP |
| 3 | INJ OUT #2 | T.P.S. +5V |
| 4 | INJ OUT #3 | WATER TEMP |
| 5 | INJ OUT #4 | T.P.S. SIG |
| 6 | AIR TEMP | OXYGEN SENSOR |
| 7 | GND | GND |
| 8 | BATT | IGN +12V |
4-way crank connector
| Relative column from left | Upper row label | Lower row label |
|---|---|---|
| 1 | POWER (RED) | CRANK INP 2 |
| 2 | GND (BLACK) | CRANK INP 1 |
The source diagram also depicts the separate MAP sensor port and refers to its second sheet for ignition wiring. The listed arrangement is for this LT-8 drawing and is not proof of wiring for the LT-8S or LTX-8 models.