
Link G4X TTX is a vehicle-specific programmable plug-in ECU for the Audi TT / VW 1.8T application listed in Link's model-specific manuals index. It is an application board, rather than the universal wire-in ECU. Check the exact vehicle, market, engine, original ECU and board part number against the manufacturer's TTX installation manual.
Identification and installation
Record the Link model label and revision, donor factory ECU connector and car's engine and year. Plug-in boards connect to particular factory-harness layouts; the family or vehicle name alone does not establish every model-year or transmission combination. The manufacturer manual gives the supported application and any installation or configuration notes for this board.
G4X plug-in platforms offer configurable fuel and ignition control but available channels and features depend on the original header and board. The G4X plug-in general specifications are conditional on the particular application and do not mean every input is brought out to the factory harness.
Pinout and tuning
The TTX installation manual is the model-specific source for board pinouts, expansion connections, electrical cautions and startup configuration. Use its connector orientation and the exact board version; do not copy a wire-in ECU pinout onto a factory harness. PCLink and manual downloads; Link manufacturer overview.
Manufacturer connector schedules
From Link's TTX installation manual (2025). Link states that its pinouts are viewed looking into the ECU from the wire side. A dash reproduces an unspecified source field; nc is Link's label. Link’s guide covers the Audi TT 1.8 turbo. CAN 2 receives factory vehicle information, including wheel speeds. DI 9, An Temp 3, An Volt 10 and ignition 6 are also present on the expansion connector. Injector drive 8 is not exposed.
Factory main header positions
| Factory pin | Link ECU channel | Factory function |
|---|---|---|
| 1 | Ground | — |
| 67 | DI 8 | Crash Signal |
| 2 | Ground | — |
| 68 | Ground (O2 Sensor 2) | — |
| 3 | +12V | ECU Power |
| 69 | An Volt 9 | O2 Sensor 2 (Some) |
| 4 | nc | — |
| 70 | An Volt 8 | O2 Sensor 1 |
| 5 | Injector 5 (Aux) | O2 Sensor #1 Heater |
| 71 | nc | — |
| 6 | nc | — |
| 72 | +5V Out (APS 2) | — |
| 7 | nc | — |
| 73 | +5V Out (APS 1) | — |
| 8 | nc | — |
| 74 | nc | — |
| 9 | nc | — |
| 75 | nc | — |
| 10 | nc | — |
| 76 | nc | — |
| 11 | nc | — |
| 77 | nc | — |
| 12 | nc | — |
| 78 | nc | — |
| 13 | nc | — |
| 79 | nc | — |
| 14 | nc | — |
| 80 | nc | — |
| 15 | nc | — |
| 81 | nc | — |
| 16 | nc | — |
| 82 | Trig 1 | Trig 1 (Crank) |
| 17 | nc | — |
| 83 | +5V Out (TPS) | — |
| 18 | nc | — |
| 84 | An Volt 4 | TPS (Sub) |
| 19 | nc | — |
| 85 | An Temp 2 | IAT |
| 20 | nc | — |
| 86 | Trig 2 | Trig 2 (Cam) |
| 21 | Power Relay Control | some models only |
| 87 | nc | — |
| 22 | nc | — |
| 88 | Injector 4 | Injection |
| 23 | nc | — |
| 89 | Injector 2 | Injection |
| 24 | nc | — |
| 90 | Ground (Trig 1) | — |
| 25 | nc | — |
| 91 | Ground (TPS) | — |
| 26 | nc | — |
| 92 | An Volt 3 | TPS (Main) |
| 27 | Ground (AFM) | — |
| 93 | An Temp 1 | ECT |
| 28 | DI 9 | Spare* |
| 94 | Ignition 4 | Ignition |
| 29 | An Volt 2 | AFM |
| 95 | Ignition 2 | Ignition |
| 30 | nc | — |
| 96 | Injector 1 | Injection |
| 31 | nc | — |
| 97 | Injector 3 | Injection |
| 32 | nc | — |
| 98 | +5V Out (MAP, Trig) | — |
| 33 | Ground (APS 2) | — |
| 99 | Ground (Knock) | — |
| 34 | An Volt 6 | APS 2 (Sub) |
| 100 | nc | — |
| 35 | An Volt 5 | APS 1 (Main) |
| 101 | An Volt 7 | Intercooler Pressure |
| 36 | Ground (APS 1) | — |
| 102 | Ignition 1 | Ignition |
| 37 | Aux 1 | Tacho |
| 103 | Ignition 3 | Ignition |
| 38 | nc | — |
| 104 | Aux 3 | Wastegate Solenoid |
| 39 | DI 4 | Clutch |
| 105 | Aux 2 | Turbo Recirculation valve |
| 40 | DI 6 | A/C Request |
| 106 | Knock 1 | Knock |
| 41 | DI 7 | A/C Compressor State |
| 107 | Knock 2 | Knock |
| 42 | nc | — |
| 108 | Ground (Shield) | — |
| 43 | nc (K Line) | — |
| 109 | nc | — |
| 44 | nc | — |
| 110 | An Temp 3 | Spare* |
| 45 | nc | — |
| 111 | An Volt 10 | Spare* |
| 46 | nc | — |
| 112 | DI 9 | Spare* |
| 47 | — | — |
| 113 | Ignition 6 (Aux) | Spare* |
| 48 | Aux 7 | CE Light |
| 114 | — | — |
| 49 | DI 5 | PS Switch |
| 115 | Injector 6 (Aux) | — |
| 50 | Ground (PS) | — |
| 116 | nc | — |
| 51 | Ground (O2 Sensor) | — |
| 117 | Aux 9 | E-Throttle Motor (+) |
| 52 | nc | — |
| 118 | Aux 10 | E-Throttle Motor (-) |
| 53 | +5V Out (AFM) | — |
| 119 | nc | — |
| 54 | DI 1 | Vehicle Speed |
| 120 | nc | — |
| 55 | DI 2 | Brake NC |
| 121 | nc | — |
| 56 | DI 3 | Brake NO |
| 57 | nc | — |
| On Board MAP | An Volt 1 | MAP |
| 58 | CAN 2 Low | — |
| 59 | nc | — |
| 60 | CAN 2 High | — |
| 61 | — | — |
| 62 | nc (+12V constant) | — |
| 63 | Injector 7 (Aux) | O2 Sensor #2 Heater |
| 64 | Aux 6 | Purge Canister |
| 65 | Aux 5 | Fuel Pump Relay |
| 66 | — | — |
Expansion connector
| Pin | Link ECU channel | Factory function |
|---|---|---|
| 1 | Ground (Signal) | — |
| 2 | +5V Out | — |
| 3 | An Temp 3 | — |
| 4 | An Volt 10 | — |
| 5 | An Volt 11 | — |
| 6 | DI 10 | — |
| 7 | DI 9 | — |
| 8 | Ignition 6 (Aux) | — |
Electronic throttle relay
| Position | Channel | Function |
|---|---|---|
| EThrottle Relay | Aux 8 | EThrottle Relay |
CAN 1/RS232 Connector
| Pin | Function | Wire colour |
|---|---|---|
| 1 | Comms GND | Brown |
| 2 | CAN1 L | Green |
| 3 | CAN1 H | White |
| 4 | RS232-RX | Grey |
| 5 | RS232-TX | Yellow |