Tuning Wiki
FuelTech FT250 installed in a race car
An FT250 installation pictured on the cover of FuelTech's FT250 / FT300 manual; image reproduced with permission.

FuelTech FT250 is a Earlier FT generation engine-management unit. Earlier programmable fuel and ignition model covered with FT300 in FuelTech’s installation guide; the manual says trigger-wheel ignition requires a FirePRO or Fire4S in its documented setup. FuelTech model documentation · FuelTech range comparison.

Identification and software

Record the exact model, serial, harness, firmware and configured outputs; similarly named FT models may use different connectors and functions. Tuning software: ECU Manager / Datalogger (earlier generation). FuelTech software and compatibility.

Wiring and pinout

Use the model-specific manual and the current FuelTech manuals index for connector view, cavity numbering, fuse values, sensor grounds and injector-driver limits. The manufacturer wiring archive contains installation-specific examples; match the exact ECU and harness before wiring. Pin functions depend on the model, hardware and configured output.

See FuelTech engine-management family for other models and company background. FuelTech is based in Brazil and has a US operation in Georgia. Sources reviewed 17 November 2026.

24-way main connector

Pin numbers and wire functions below follow FuelTech's FT250 / FT300 manual, section 5.1; view the connector from the harness rear as shown in section 5.2. The FT250 uses only ignition output A; E, D, C and B are marked unavailable on FT250. The FT300 supports the additional ignition outputs. Check the actual configuration, sensor wiring, ignition driver and ground instructions.

PinFunction and harness wire
1Tachometer output (green)
2Auxiliary output 3 (yellow 3)
3Intake air temperature input (white/blue)
4Auxiliary output 2 (yellow 2)
5Fuel/oil pressure or lambda input (white)
6Auxiliary output 1 (yellow 1)
7Coolant temperature input (pink)
8Auxiliary output 4 (yellow 4)
9Fuel/oil pressure or two-step input (blue)
10Ignition output E (gray E)
11Throttle position signal (orange)
12Ignition output D (gray D)
13MAP signal output (yellow/red)
14Ignition output C (gray C)
15Cam sync / FT250 MAP–MAF clamper, see note (green/yellow)
16Ignition output B (gray B)
17RPM signal input (shielded cable)
18Ignition output A (gray A)
19Battery negative / signal ground (black)
205 V sensor supply (green/red)
21Switched 12 V supply (red)
22Power / chassis ground (black/white)
23Fuel injector bank B negative (brown)
24Fuel injector bank A negative (purple)

FT250 source ambiguity: the wiring table identifies pin 15 as the MAP/MAF clamper connection for FT250, while the figure note appears to describe pin 13 as the clamper. Confirm the exact FT250 harness and corrected guidance with FuelTech before connecting this function.

FuelTech FT250 ECU
FT250 product photograph from the FuelTech manufacturer media kit, reproduced with permission.

Directly applicable articles

Technical articles assigned to this context will appear here.

Shared family guidance

From parent families. Broader context does not establish compatibility with this ECU or software version.