
The EMU Black is a universal port-injection ECU with a 4 bar internal MAP sensor, two EGT and two knock inputs, CAN and a direct LSU 4.2 or 4.9 wideband controller. Six high-impedance injector drivers and two shared auxiliary drivers give up to eight injector outputs; six ignition outputs and one electronic throttle controller are listed. The case is IP60. Application-specific Black plug-in ECUs use their own enclosure and pinout. Manufacturer product specification · Manufacturer comparison.
Connector pinout and wiring
Black 39-way and grey 24-way FCI connectors; the connector names describe colour, not ECU model. The table below applies to the universal wire-in EMU Black. Exact-model manufacturer pinout.
EMU Black pinout
Universal EMU Black wire-in ECU only. Connector colour and pin numbers follow ECUMaster's EMU Black pinout PDF; refer to the manufacturer's drawings for connector view and orientation, electrical limits, sensor wiring and setup. Shared outputs depend on calibration.
Black 39-pin connector
| Pin | Function |
|---|---|
| 1 | Ignition coil 5 |
| 2 | EGT input 1 |
| 3 | Knock sensor input 1 |
| 4 | Analogue input 2 |
| 5 | Coolant temperature input |
| 6 | Wideband oxygen Vs |
| 7 | Cam sync input 2 |
| 8 | Primary trigger |
| 9 | Flex fuel input |
| 10 | Switch input 1 |
| 11 | RS232 TXD |
| 12 | CAN high |
| 13 | Battery +12 V |
| 14 | Ignition coil 4 |
| 15 | EGT input 2 |
| 16 | Knock sensor input 2 |
| 17 | Analogue input 3 |
| 18 | Throttle position input |
| 19 | Wideband oxygen Ip |
| 20 | Vehicle speed input |
| 21 | Cam sync input 1 |
| 22 | Wideband oxygen Rcal |
| 23 | Switch input 2 |
| 24 | RS232 RXD |
| 25 | CAN low |
| 26 | 5 V supply |
| 27 | Power ground |
| 28 | ECU ground |
| 29 | Sensor ground |
| 30 | Analogue input 4 |
| 31 | Analogue input 1 |
| 32 | Intake air temperature input |
| 33 | Wideband oxygen VGND |
| 34 | 5 V supply |
| 35 | Analogue input 5 |
| 36 | Switch input 3 |
| 37 | Analogue input 6 |
| 38 | Sensor ground |
| 39 | Sensor ground |
Grey 24-pin connector
| Pin | Function |
|---|---|
| 1 | Ignition coil 6 |
| 2 | H-bridge 1 winding A |
| 3 | H-bridge 2 winding A |
| 4 | AUX 6 |
| 5 | AUX 3 |
| 6 | Injector 4 |
| 7 | Injector 1 |
| 8 | Ignition coil 1 |
| 9 | Ignition coil 3 |
| 10 | H-bridge 1 winding B |
| 11 | H-bridge 2 winding B |
| 12 | AUX 5 |
| 13 | AUX 2 / injector 8 |
| 14 | Injector 5 |
| 15 | Injector 2 |
| 16 | Ignition coil 2 |
| 17 | Power ground |
| 18 | Ignition +12 V |
| 19 | Wideband oxygen heater |
| 20 | AUX 4 / tacho |
| 21 | AUX 1 / injector 7 |
| 22 | Injector 6 |
| 23 | Injector 3 |
| 24 | Power ground |
Software and installation
Record the ECU serial, firmware, software and project versions and confirm assigned outputs and trigger inputs before connecting loads. The manufacturer downloads contain current software, manuals and supported base maps. Base maps do not establish the correct pinout for a particular vehicle. Compare with the ECUMaster family guide.
Vehicle-specific EMU Black plug-in ECU pages
These are complete plug-in ECU applications, separate from universal ECUs and adapter interconnectors. Exact wiring, enclosure, firmware and fitment vary.
- Lotus S2 Rover K4 — RRR package
- MINI Cooper R50
- MINI Cooper R53
- Lotus 2ZR-FE
- Lotus 2ZZ-GE drive-by-wire
- VW/Audi 1.8T BAM and listed variants
- VW R32 BFH
- VW R32 BUB
The manufacturer catalogue marks Audi RS4 ASJ/AZR and Nissan 200SX S13 SR20DET as “not yet” available; these are not counted as confirmed released models. ECUMaster catalogue.