Hardware revisions
Voodoo Pro V1 and Voodoo Pro V2 have separate manufacturer quick-start guides. V1 has a six-way CAN 1/K-line port; V2 uses a four-way CAN 1 port and a separate Ethernet connector. Header assignments also differ, so use the appropriate revision's guide rather than assuming a shared pinout.
Link G5 Voodoo Pro is a programmable G5 wire-in engine-management ECU. Manufacturer lists up to 12-cylinder control and dual onboard lambda sensor control. Some injector/ignition/auxiliary drives have shared uses; check the model revision and allocation. Link G5 Voodoo Pro quick-start guide.

Model identification and I/O
| Item | Documented details |
|---|---|
| ECU family | G5 |
| Outputs | Up to 16 injection and 12 ignition drives |
| Programming | PCLink version matched to ECU generation and firmware |
| Connector and loom | See the exact-model guide, including connector keys, wire-side orientation and optional functions |
The manufacturer guidance and wiring identify the hardware; driver counts do not establish injector electrical compatibility or imply all multiplexed pins can be used at the same time.
Model-specific pinout and installation
The G5 Voodoo Pro quick-start guide provides the connector diagrams and installer I/O table. Refer to that version for numbered cavities, wire colours, supply, grounds, driver and sensor connection notes. Loom wire-side and ECU header views are identified on the diagram; do not transfer a pin number from another generation.
The manufacturer publishes separate Voodoo Pro V1 and V2 guides: establish the revision before using a pinout.
Software and further sources
Download software, firmware and full installation help from Link's download centre; identify the ECU generation and installed firmware before choosing a PCLink package. The legacy software list separates G5, G4X and G4+ compatibility. See also Link standalone ECUs.