Canems' 6 and 8 cylinder ignition ECU manual, release 1.00 describes a programmable ignition-only ECU for carburetted applications. It has four high-current outputs for wasted spark on engines up to eight cylinders. This product does not provide active fuel injection in the documented ignition-only configuration.
Control and specifications
The manual lists two 180-site ignition maps, map switching, soft and hard rev limits, adjustable coil dwell, spark-based idle correction, and an RPM-controlled or PWM auxiliary output. It describes 36-1 and 60-2 crank patterns, with firmware dependent selection, and MAP or throttle load sensing. Manual figures for this configuration include a 7–18 V negative-earth supply, four ignition outputs rated up to 10 A each, and 30-way connector.
Software and identification
The document states that the ignition ECU uses the same tuning software as the injection ECU, and that fuel-related software settings have no effect on an ignition-only ECU. It describes factory reprogramming for an upgrade to full injection specification; actual hardware and available service must be confirmed with Canems. Identify the model and firmware before applying any settings.
Wiring evidence
The original release 1.00 ignition manual contains the eight-cylinder wiring diagram and loom connections. It identifies 3A ECU ground, 3B supply, 2A map switch, 3J configurable output 1 and 3K tachometer. Do not infer unused or injection pins from the separate Injection ECU table: confirm the harness, orientation and exact hardware against the manual.
Ignition ECU connector table — release 1.00
Canems' six- and eight-cylinder ignition manual lists these loom connections. It does not list every possible cavity; blank positions are not confirmed available. Use the manufacturer connector drawing and cavity markings to establish orientation.
| Cavity | Function |
|---|---|
| 1F | Ignition output 4 |
| 1G | Ignition output 3 |
| 1H | Ignition output 2 |
| 1J | Ignition output 1 |
| 1K | Ignition earth |
| 2A | Map switching input |
| 2C | Coolant temperature |
| 2D | Throttle position |
| 2E | MAP sensor |
| 2H | 5 V reference |
| 2K | Output 2, PWM capable |
| 3A | ECU earth |
| 3B | 12 V supply |
| 3C | Crank sensor earth and shield |
| 3D | Crank sensor signal |
| 3F | Serial ground |
| 3G | Serial receive |
| 3H | Serial transmit |
| 3J | Output 1 |
| 3K | Tachometer |