Tuning Wiki

Model and vehicle application

Syvecs lists this vehicle-specific standalone or plug-in ECU kit as Toyota GR Yaris Gen2 2024 onward Manual, with product code SGDI-Yaris2024. The product page and its stated vehicle, model and transmission details define this particular application; confirm market, model year, engine, ECU connector and transmission against Syvecs before ordering.

This entry describes the dedicated vehicle kit. It is distinct from the generic wire-in ECU: a plug-in kit can use application-specific adaptor wiring, a carrier, additional modules and an application calibration. The listed hardware or supported equipment can vary by revision.

Wiring and pinout

Syvecs Toyota GR Yaris Gen2 2024 onward Manual installation and wiring document. Follow the connector orientation, application-specific tables, installation notes and hardware revision in this document. Do not transfer assignments from another vehicle merely because the underlying ECU family is similar. The link was checked to return a PDF.

For other variants and manual revisions consult the manufacturer's vehicle-specific manual index. Available spare inputs and outputs can be used only within their electrical limits and with a matching calibration.

Calibration and service

Use the correct Syvecs software, firmware and base calibration for the exact vehicle and installed hardware. The Syvecs software portal and firmware archive provide manufacturer support. A base map is a starting point and needs checking against the actual engine, injectors, sensors and modifications.

Sources

26-way additional I/O header

The Syvecs application manual documents the rear additional I/O header. This is not the OEM vehicle connector pinout. Verify hardware revision, connector view, current limits and configuration; a pin labelled available may be assigned to an existing device.

PinSyvecs functionSource note
1Ground—
2K-type −—
3K-type +—
4GDI4−—
5GDI4+—
6Out1 / Slave1Out1Spare output if OEM Denso is not used
7Vbat12 V bench supply or NTK lambda heater output
8Fuel11Spare output
9RS232 RX—
10Lam1vNTK L2H2 gray wire
11Lam1iNTK L2H2 white wire
12LamGndNTK L2H2 black wire
13Vbat-–Source describes 12 V bench supply or NTK heater output; confirm label
145 V regulated supply—
15RS232 TX—
16CAN2LExpansion / dashboard CAN low
17CAN2HExpansion / dashboard CAN high
18CAN3LExpansion / dashboard CAN low
19CAN3HExpansion / dashboard CAN high
20Out4 / Slave1Out4Spare output
21AN01Input
22S1AN05 / Slave1AN05Input
23LAN RX−Orange/white
24LAN RX+White/orange
25LAN TX−Green/white
26LAN TX+White/green

Pin 13 is written “Vbat-–” while the same sentence describes a 12 V supply or heater output. Confirm the polarity with Syvecs for the actual hardware before connecting it. The source does not provide the full OEM vehicle main-connector schedule here.

Directly applicable articles

Technical articles assigned to this context will appear here.