Tuning Wiki

Link G4+ Storm is a programmable G4+ wire-in engine-management ECU. A/B loom unit; its guide lists eight analogue voltage inputs, three temperature inputs and two knock inputs. Link G4+ Storm quick-start guide.

Model identification and I/O

ItemDocumented details
ECU familyG4+
Outputs8 injection and 8 ignition drives
ProgrammingPCLink version matched to ECU generation and firmware
Connector and loomSee the exact-model guide, including connector keys, wire-side orientation and optional functions

The manufacturer guidance and wiring identify the hardware; driver counts do not establish injector electrical compatibility or imply all multiplexed pins can be used at the same time.

Model-specific pinout and installation

The G4+ Storm quick-start guide provides the connector diagrams and installer I/O table. Refer to that version for numbered cavities, wire colours, supply, grounds, driver and sensor connection notes. Loom wire-side and ECU header views are identified on the diagram; do not transfer a pin number from another generation.

Software and further sources

Download software, firmware and full installation help from Link's download centre; identify the ECU generation and installed firmware before choosing a PCLink package. The legacy software list separates G5, G4X and G4+ compatibility. See also Link standalone ECUs.

Link G4+ storm ECU
G4+ Storm as shown in Link’s catalogue; confirm the hardware revision. Image: Link Engine Management G4+ catalogue, reproduced with permission.

Directly applicable articles

Technical articles assigned to this context will appear here.