Tuning Wiki

Link G3 LinkPlus is a documented G3 Link engine-management designation. Link's support forum lists a LinkPlus G3 wiring and installation manual. The manufacturer connector kit for G3 LinkPlus uses four housings, distinguishing it from the single 26-way G3 LEM connector. Identification source.

Identification and software

Record the complete model and revision label, board identifiers, installed firmware, connector configuration and any adapter loom. Similar Link model names occur in later generations. Use the manufacturer's legacy PCLink compatibility table and seek Link support if the appropriate package is unclear.

Model-specific wiring

The identified manufacturer documentation or legacy manual archive is the starting point for this model. An individual pin-by-pin allocation was not verified in this reference; obtain the exact matching manual and connector orientation before wiring.

See Link standalone ECUs for related models and generation distinctions.

LinkPlus G3 breakout loom colour reference

The following signal and loom-colour list comes from Link Electrosystems drawing G06, LinkPlus G3 ECU Pinout, version 1.0, as reproduced in an archival copy. This is a wire-colour reference, not a numbered connector-cavity map. The diagram says to view the ECU header from the connector wire side. Confirm connector positions against the original drawing and the exact ECU, loom and internal build. The manufacturer's G2/G3 manual index lists the LinkPlus G3 wiring manual. Do not transfer these colours to LEM G3, G1 or G2 models.

SignalLink G06 loom colour
Injector 1Brown/Black
Injector 2Brown
Injector 3Brown/Red
Injector 4Brown/Orange
Injector 5Brown/Yellow
Injector 6Brown/Green
Injector 7Brown/Blue
Injector 8Brown/Purple
Ignition 1Blue/Black
Ignition 2Blue/Brown
Ignition 3Blue/Red
Ignition 4Blue/Orange
Ignition 5Blue/Yellow
Ignition 6Blue/Green
Ignition 7Blue
Ignition 8Blue/Purple
Auxiliary output 1Orange/Black
Auxiliary output 2Orange/Brown
Auxiliary output 3Orange/Red
Auxiliary output 4Orange
Auxiliary output 5Orange/Yellow
Auxiliary output 6Orange/Green
Auxiliary output 7Orange/Blue
Auxiliary output 8Orange/Purple
Digital input 1Grey/Black
Digital input 2Grey/Brown
Digital input 3Grey/Red
Digital input 4Grey/Orange
Digital input 5Grey/Yellow
Digital input 6Grey/Green
Digital input 7Grey/Blue
Digital input 8Grey
Analogue voltage input 1White/Black
Analogue voltage input 2White/Brown
Analogue voltage input 3White/Red
Analogue voltage input 4White/Orange
Analogue voltage input 5White/Yellow
Analogue voltage input 6White/Green
Analogue temperature 1Yellow (ECT)
Analogue temperature 2Yellow/Brown (IAT)
Analogue temperature 3Yellow/Red
Analogue temperature 4Yellow/Orange
Load 1 (MAP)White/Blue
Load 3 (TPS)White
Trigger 1Yellow, screened cable
Trigger 2Blue, screened cable
Knock 1Blue, screened cable
Knock 2Blue, screened cable
Power +12VRed
Power groundBlack
Sensor groundGreen
+5V outputRed/Blue
+8V outputRed/White

Colours and labels refer to Link's G3 loom, and are not a substitute for identifying cavity orientation, ECU configuration and actual wiring. A different or repaired loom can use different colours.

Directly applicable articles

Technical articles assigned to this context will appear here.

Continue the conversation

If this topic interests you, consider joining the following forums. They host material referenced in this article.