The ME100 is an ignition-only member of the ME range, not a complete fuel-injection ECU. The older GEN1 wire-in documentation groups it with ME221 and shows a 12-way plus 16-way connector. Hardware and software versions must be identified before using the source table. Manufacturer documentation · ME manuals and downloads.
Identification and configuration
Record the complete model label, serial number, hardware generation, firmware and harness. Wire-in ECUs and vehicle-specific plug-in versions have different physical connections. Software and output assignments depend on the unit and calibration; follow the appropriate manufacturer wiring guide and check the installed configuration.
GEN1 28-way connector pinout
The manufacturer identifies 12-way and 16-way plugs and depicts the ECU header / loom wire-side view. The functions in parentheses labelled ME100 refer to the ignition-only model, not ME221 injector assignments. GEN1 ME100/ME221 wiring source.
| Pin | Function, including ME100 annotation | Manufacturer loom colour |
|---|---|---|
| 1 | Injector 4 | GREEN/ORANGE |
| 2 | Low Side Output 3 (LS7 on ME100)* | BLUE/RED |
| 3 | Low Side Output 2 (LS6 on ME100)* | BLUE/BROWN |
| 4 | Injector 2 (LS5 on ME100) | GREEN/BROWN |
| 5 | Injector 1 (LS4 on ME100) | GREEN/BLACK |
| 6 | Low Side Output 1 (LS5 on ME100)* | BLUE/BLACK |
| 7 | Injector 3 (LS6 on ME100) | GREEN/RED |
| 8 | Tachometer Output (12V) | BROWN |
| 9 | GROUND | BLACK |
| 10 | Coil A / 1 (Cylinders 1 & 4)** | BLUE |
| 11 | GROUND | BLACK |
| 12 | Coil B / 2(Cylinders 2 & 3)** | GREEN |
| 13 | 12V Ignition Switched Power (5A Fused) | RED |
| 14 | 5V Reference Output | PURPLE |
| 15 | CAM Sensor +ve | WHITE in SHIELDED RED |
| 16 | CRANK Sensor -ve (leave unconnected for hall/opto) | BLUE in SHIELDED BLACK |
| 17 | HS_Digital_Input_2 | RED/WHITE |
| 18 | Intake Air Temperature Signal (Pulled up via 2K7 Ohms) | ORANGE |
| 19 | Coolant Temperature Signal (Pulled up via 2K7 Ohms) | YELLOW |
| 20 | O2 Sensor Signal (0-5v, Narrow or Wideband) | RED/BLACK |
| 21 | Knock -ve | BLUE |
| 22 | CAM Sensor -ve (leave unconnected for hall/opto) | BLUE in SHIELDED RED |
| 23 | CRANK Sensor +ve | WHITE in SHIELDED BLACK |
| 24 | Knock +ve | White |
| 25 | Spare Analog 1 (0-5v) | RED/BLUE |
| 26 | MAP Sensor Signal | GREY |
| 27 | TPS Sensor Signal | PINK |
| 28 | Analog/Sensor Ground | BLACK |
The same source labels pins 4 and 6 “LS5 on ME100”; treat this as an unresolved source inconsistency and confirm with the manufacturer before using those ME100 outputs.
Software and further information
ME provides MEITE / EZ Tune, firmware and installation guides on its support page. Confirm the software and firmware required by the actual unit. See Motorsport Electronics ECU family.
Sources reviewed 17 November 2026.