
ECUMaster Benelux lists an EMU Black-based Lotus S2 K4 Rover engine plug-in ECU. Its linked installation manual is authored by Road Race Rally Engineering (RRR), and describes an application-specific ECU, mounting plate, auxiliary connector and wideband sensor. This is an ECU package using the Black platform; distinguish it from the universal Black wire-in unit and from the separate Lotus 2ZZ and 2ZR plug-in models. ECUMaster Benelux product and photographs · RRR installation manual.
Application and setup
The manual specifies the Lotus S2 Rover K4 application; confirm the car, engine, ECU and loom with the supplier. It describes a supplied starting map and explicitly limits it to starting and stationary testing before calibration. Its installation steps include changes to the fuse and idle-valve wiring as well as fitting the wideband sensor. Do not infer a no-modification installation: read the exact instructions for the supplied kit.
Back spare connector pinout
The RRR manual gives the following 26-way rear auxiliary connector, not the factory ECU connector. Refer to the original connector view, terminal specification, loom and wiring instructions. The unused entries below are as documented; they do not establish their electrical state in every hardware revision. RRR function assignment and connector reference, rev.3.
| Position | Function in source |
|---|---|
| 1 | 12 V from main relay |
| 2 | Power ground |
| 3 | CAN H |
| 4 | CAN L |
| 5 | TXD |
| 6 | RXD |
| 7 | Flex fuel input |
| 8 | 5 V supply |
| 9 | Analogue input 5 |
| 10 | Analogue input 6 |
| 11 | EGT input 2 |
| 12 | Sensor ground |
| 13 | EGT input 1 |
| 14 | N.C. in source |
| 15 | N.C. in source |
| 16 | N.C. in source |
| 17 | N.C. in source |
| 18 | N.C. in source |
| 19 | N.C. in source |
| 20 | 12 V from main relay |
| 21 | Wideband heater |
| 22 | Wideband Ip |
| 23 | Wideband Vs |
| 24 | Wideband Rcal |
| 25 | Wideband VGND |
| 26 | Power ground |
Model-specific I/O
The RRR function list assigns ignition channels 1 and 2 to cylinders 1/4 and 2/3 respectively; other ignition driver channels are used for cooling fans, fuel pump and main relay in its listed calibration. Injector outputs 1–4 are assigned to their corresponding cylinders. These are the application's listed functions, not a universal EMU Black harness. See the manufacturer index.