Tuning Wiki
Omex 600 series engine management unit
Omex 600 series. Photo: Omex Technology; source: Omex engine management. Reproduced with permission.

The 600-series ECU controls fuel and ignition for four-cylinder engines with fixed or two-stage cams, according to Omex. The 2v20 installation manual lists trigger-pattern examples including Ford 36-1, Bosch 60-2, Toyota 36-2 and specified Rover and Honda patterns. Sensor type and configuration are hardware-specific. Model-specific Omex manual · Omex engine-management range.

Connector and pinout

The 36-way loom connector assignments below are from Omex 600 installation manual 2v20 pages 39–40; diagrams establish the wire-side orientation. Blank or unused pins are not an invitation to add loads. Open the exact-model installation or hardware manual.

Omex 600 connector pinout

Selected complete listed functions from OMEM600 installation manual 2v20, section 5.3. The manual depicts the connector from the wiring-loom side; consult its diagram and check terminal numbering before wiring. Blank pins in the source are omitted and should not be treated as available. Configurable auxiliary functions depend on setup. Omex 600 installation manual, pages 39–40

PinFunction
1AIgnition 1
2AAux out 4
3AIdle 4
4ABattery power
5AChassis earth 1
6ASensor ground
7ACrank sensor
8ATiming ground
9ACoolant temperature sensor
10AAux in 1
12AIgnition 2
1BInjection 1
2BInjection 2
3BIdle 3
4BAux out 1
5BFuel pump
6BMAP sensor
7BChassis earth 2
8BShift light
9BAir temperature sensor
11BAux in 2
12BAux out 2
2CIdle 2
3CIdle 1
4CAux out 3
6CRadiator fan relay
7COxygen sensor
8CThrottle position sensor
9C5 V out
10CRoad speed sensor
11CAux in 3
12CTacho

Software and setup

Omex lists MAP4000 for its current ECU range; check the exact unit, firmware and communications lead before attempting to connect. Record ECU serial and firmware, save the existing calibration, and confirm crank trigger, injector, coil, sensors and assigned outputs against the matching manual. Manufacturer startup calibrations require verification and adjustment for the actual engine.

Compare models and historical identities in the Omex family guide.

Directly applicable articles

Technical articles assigned to this context will appear here.