
Link G4X RX7S6X is a vehicle-specific programmable plug-in ECU for the Mazda RX-7 series 6 application listed in Link's model-specific manuals index. It is an application board, rather than the universal wire-in ECU. Check the exact vehicle, market, engine, original ECU and board part number against the manufacturer's RX7S6X installation manual.
Identification and installation
Record the Link model label and revision, donor factory ECU connector and car's engine and year. Plug-in boards connect to particular factory-harness layouts; the family or vehicle name alone does not establish every model-year or transmission combination. The manufacturer manual gives the supported application and any installation or configuration notes for this board.
G4X plug-in platforms offer configurable fuel and ignition control but available channels and features depend on the original header and board. The G4X plug-in general specifications are conditional on the particular application and do not mean every input is brought out to the factory harness.
Pinout and tuning
The RX7S6X installation manual is the model-specific source for board pinouts, expansion connections, electrical cautions and startup configuration. Use its connector orientation and the exact board version; do not copy a wire-in ECU pinout onto a factory harness. PCLink and manual downloads; Link manufacturer overview.
Manufacturer connector schedules
From Link's RX7S6X installation manual. Pinouts are viewed looking into the ECU from the wire side. A dash reproduces an unspecified source field; nc is Link's label. Confirm the exact board revision and vehicle harness before use.
Factory main header
| Factory pin | Link ECU channel | Factory function |
|---|---|---|
| 1 | Injector 2 | Rear Primary Injector |
| 51 | nc | — |
| 2 | Injector 1 | Front Primary Injector |
| 52 | Injector 7 (Aux) | CAT Light (CE Light) |
| 3 | Aux 1 | Boost Solenoid |
| 53 | nc | — |
| 4 | nc | — |
| 54 | nc | — |
| 5 | Aux 2 | ISC Solenoid |
| 55 | nc | — |
| 6 | nc | — |
| 56 | nc | — |
| 7 | Aux 3 | Fuel Pressure Regulator (PRC) Solenoid |
| 57 | nc | — |
| 8 | Aux 5 | Metering Oil Pump (Rotary Oil Pump) |
| 58 | nc | — |
| 9 | Aux 6 | Metering Oil Pump (Rotary Oil Pump) |
| 59 | nc | — |
| 10 | Trig 2 | Trig 2 |
| 60 | nc | — |
| 11 | Trig 1 | Trig 1 |
| 61 | nc | — |
| 12 | Ground | — |
| 62 | Aux 4 | Tacho |
| 13 | Ground | — |
| 14 | Injector 4 | Rear Secondary Injector |
| 71 | An Temp 3 | Fuel Temp |
| 15 | Injector 3 | Front Secondary Injector |
| 72 | nc | — |
| 16 | nc | — |
| 73 | DI 2 | Clutch Switch (Some models) |
| 17 | nc | — |
| 74 | An Volt 3 | MAP Signal |
| 18 | nc | — |
| 75 | DI 1 | Vehicle Speed |
| 19 | nc | — |
| 76 | Injector 8 (Aux) | Fuel Pump Speed Relay |
| 20 | nc | — |
| 78 | Ignition 3 | Ignition Front Trailing |
| 21 | Aux 7 | Metering Oil Pump (Rotary Oil Pump) |
| 79 | DI 3 | A/C Request |
| 22 | Aux 8 | Metering Oil Pump (Rotary Oil Pump) |
| 80 | DI 4 | Start Signal |
| 23 | Ground (CAS) | — |
| 81 | nc (Constant +12V) | — |
| 24 | nc | — |
| 82 | nc | — |
| 25 | Ground (Sensor) | — |
| 83 | Injector 6 (Aux) | Fuel Pump Relay |
| 26 | Ground | — |
| 84 | nc | — |
| 85 | nc | — |
| 31 | nc | — |
| 86 | DI 5 | PS Switch |
| 32 | Knock 1 | Knock |
| 87 | Ignition 4 (Aux) | A/C Relay |
| 33 | nc | — |
| 88 | Ignition 2 | Ignition Rear Trailing |
| 34 | +5V Out | — |
| 89 | Ignition 1 | Ignition Leading |
| 35 | An Volt 1 | TPS Signal |
| 90 | nc | — |
| 36 | An Temp 2 | ECT |
| 91 | nc | — |
| 37 | An Volt 4 | Oxygen Sensor Signal |
| 92 | +14V Main Relay | ECU Power |
| 38 | An Volt 2 | Metering Oil Pump Position Signal |
| 39 | nc | — |
| 40 | nc | — |
| 41 | An Temp 1 | IAT |
| 42 | nc | — |
| 43 | nc | — |
| 44 | nc | — |
| 45 | Injector 5 (Aux) | Engine Fan Relays |
| 46 | nc | — |
Expansion connector
| Position | Link ECU channel | Function |
|---|---|---|
| Expansion 1 | Signal Ground | — |
| Expansion 2 | +5V Out | — |
| Expansion 3 | DI 6 | — |
| Expansion 4 | - | — |
| Expansion 5 | An Volt 5 | — |
| Expansion 6 | An Volt 6 | — |
| Expansion 7 | - | — |
| Expansion 8 | - | — |
CAN 1 / RS232
| Pin | Function | Wire colour |
|---|---|---|
| 1 | Comms GND | Brown |
| 2 | CAN1 L | Green |
| 3 | CAN1 H | White |
| 4 | RS232-RX | Grey |
| 5 | RS232-TX | Yellow |