MED 9.2.1 is the direct-injection controller pair on the N73B60. The engine sheet lists two of these units, plus a Valvetronic control unit and two HDEV control units. The V12 it replaced, the M73B54, used two ME 5.2 controllers and the earlier electronic throttle. This page is that N73 arrangement. It is not the MED9.1 controller used on other manufacturers' direct-injection fours.
The N73B60 on that sheet is a 60-degree V12 of 5,972 cc, bore 89 mm and stroke 80 mm, cylinder spacing 98 mm, main bearings 70 mm, connecting-rod big ends 54 mm. Output is 320 kW, 438 horsepower, at 6,000 rpm, and 600 Nm at 3,950 rpm. Idle is 550 rpm and the maximum is 6,500 rpm. Compression is 11.3:1. Four valves per cylinder, intake diameter 35 mm, exhaust 29 mm, intake lift 0.3 to 9.85 mm, exhaust lift 9.7 mm. Weight is 280 kg. Injection pressure is 50 to 120 bar, against 3.5 bar on the M73. Consumption is given as 12 percent below the M73. The emissions level on the sheet is LEV. Firing order is 1-7-5-11-3-9-6-12-2-8-4-10. Premium unleaded, with knock control. Regulated top speed is 250 km/h.
The intake is a magnesium shell with a chamber for each bank, bonded and bolted. The halves are not separated in service. The shell is dip-coated, and so are the bolts of the parts attached to it. A damaged bolt is replaced so the coating is not left broken. Gaskets are captured in retainers. Rubber elements under the bolts isolate the manifold from the engine. Each bank has a manifold pressure sensor, a throttle and a crankcase-ventilation pressure valve.
Processor
AutoTuner's compatibility list gives the MED9.2.1 microcontroller as the MPC555 (tool compatibility listing; single source). The listing does not name the vehicle, so its link to the N73B60 is not established.
The rest of this petrol generation, including the port-injection ME 9.2 used on the N62, is on BMW petrol engine management. The engine variants are on N73.
Sources
- AutoTuner: ECU compatibility list, tool-vendor PDF dated 28 October 2026. Accessed 19 November 2026.