MicroTech LT-9c is a standalone or earlier programmable engine-management system. LT-9c has four high-impedance injector and four ignition drivers. Manufacturer specification identifies support for up to four cylinders or two rotors, subject to configuration. Model-specific information.
Identification and features
Record the ECU label, model, part number, hardware revision, firmware, configured injectors, ignition hardware and loom before comparing systems. Some outputs can be reassigned; hardware, software, current limits and engine-specific options determine what is actually available.
Wiring and pinout
Consult the MicroTech LT-9c wiring and documentation source and identify the exact connector face, part and version. Do not apply wiring from a similarly named model. If an exact drawing is unavailable for the unit at hand, obtain it from the manufacturer or supplier before making connections.
Further information
Manufacturer shared connector drawing
MicroTech's LT9/10 wiring archive states that LT-9c and LT-10 use the same wiring diagrams. The example below is from its LT-10 4-cylinder sequential/direct-fire drawing, revision 1.0, 4 October 2004; other engine and ignition configurations are linked in the archive. Columns are relative positions left to right in the drawing's ECU view, not manufacturer pin numbers, which the diagram does not provide. Check the exact unit and engine-specific loom with MicroTech before wiring.
The drawing's injector loading examples are for its LT-10 configuration; they do not establish LT-9c driver ratings. Check the LT-9c manufacturer's specifications and the actual injectors separately.
24-way main connector
| Relative column from left | Upper row | Lower row |
|---|---|---|
| 1 | IGN OUTPUT #2 | IGN OUTPUT #1 |
| 2 | IGN OUTPUT #4 | IGN OUTPUT #3 |
| 3 | AUX OUT #3 | TACH OUTPUT |
| 4 | AUX OUT #2 | AUX INPUT #2 |
| 5 | AUX OUT #1 | AUX INPUT #1 |
| 6 | INJ OUT #1 | FUEL PUMP |
| 7 | INJ OUT #2 | T.P.S. +5V |
| 8 | INJ OUT #3 | WATER TEMP |
| 9 | INJ OUT #4 | T.P.S. SIG |
| 10 | AIR TEMP | OXYGEN SENSOR |
| 11 | GND | GND |
| 12 | BATT | IGN +12V |
4-way crank connector shown in the same drawing
| Relative column from left | Upper row | Lower row |
|---|---|---|
| 1 | POWER N/C (drawing label) | CRANK INP 2 |
| 2 | GND | CRANK INP 1 |
Ignition trigger wiring varies with the engine and hardware; use the ignition page and model-specific diagram from the manufacturer archive.
Wideband controller connections
MicroTech's LSU 4.9 wideband kit guide identifies these 9C ECU connections. The guide says to splice the LSU controller's brown ground lead into the matching brown sensor-ground wire on the ECU's 24-way main harness. This table covers the wideband signal and ground only, not the full ECU connector.
| ECU wire | Function |
|---|---|
| Black/red | Oxygen sensor input |
| Brown | Oxygen sensor ground |