Tuning Wiki
Vi-PEC iSupra ECU in an open enclosure
Vi-PEC iSupra i-Series plug-in ECU shown as a family illustration; this V-Series model's board, enclosure and vehicle connectors differ. Image: Link Engine Management Vi-PEC product archive, reproduced with permission.

Vi-PEC V Series Mazda RX7 S7-8 is a V Series plug-in ECU documented for Mazda RX-7 Series 7–8. It is a vehicle-specific replacement board, and the precise model year, engine, ECU connector and market variant must be checked against the installation guide. Link's Vi-PEC manual index.

Installation and pin functions

Use the specific Vi-PEC installation manual for this application. Its installation instructions and pin-function sections identify connections and application differences; a similarly named V Series plug-in board for another vehicle must not be used as a wiring reference. Check the original ECU part number and wiring before fitting.

Programming and support

Link lists Vi-PEC Tuning Software (VTS) for the V Series. Firmware compatibility and the calibration depend on the ECU version. Consult the software archive and retain the original calibration before any change.

Identification limits

This page is indexed by the documented application rather than an independently verified manufacturer SKU. Check the manual for exact compatibility and do not infer additional vehicle fitments.

Manufacturer pinout tables

All positions listed in the application-specific Vi-PEC installation guide, page 21–22, are shown below. The drawing uses a view looking into the ECU from the wire side. Positions omitted by the source are not assumed unused; configure the channels for the vehicle. The guide shows different assignments on lower PCB revisions V1.0–1.1 and V1.2, notably pins H, 4L, 4V and 4AG. Check the actual lower-board revision before making connections.

Main ECU connector: documented positions

PositionLower PCB V1.0–1.1Lower PCB V1.2
CAux 2Aux 2
HAux 3Injection 7
OAux 1Aux 1
QInjection 1Injection 1
SAux 7Aux 7
UInjection 2Injection 2
WAux 6Aux 6
YInjection 3Injection 3
AAAux 8Aux 8
ACInjection 4Injection 4
AEAux 5Aux 5
3DAn Volt 1An Volt 1
3HAn Volt 3An Volt 3
3IAn Volt 2An Volt 2
3RTrig 1Trig 1
3TAn Temp 3An Temp 3
3UTrig 2Trig 2
3VAn Temp 1An Temp 1
3WAn Temp 2An Temp 2
4CDigital Input 6Digital Input 6
4FInjection 5Injection 5
4GInjection 6Injection 6
4IIgnition 4Ignition 4
4KAux 3Aux 3
4LAux 3Injection 8
4MAux 4Aux 4
4QDigital Input 3Digital Input 3
4SDigital Input 4Digital Input 4
4VDigital Input 1A/C Request
4WDigital Input 2Digital Input 2
4AFIgnition 3Ignition 3
4AGDigital Input 5A/C Sw itch
4AHAn Volt 4An Volt 4
4AJIgnition 2Ignition 2
4ANIgnition 1Ignition 1

Other connections

PositionECU function
Expansion 1Signal GND
Expansion 2+5V Out
Expansion 3Digital Input 8
Expansion 4Digital Input 7
Expansion 5An Volt 5
Expansion 6An Volt 6
Expansion 7An Volt 7
Expansion 8An Temp 4

Directly applicable articles

Technical articles assigned to this context will appear here.