Tuning Wiki
Vi-PEC iSupra ECU in an open enclosure
Vi-PEC iSupra i-Series plug-in ECU shown as a family illustration; this V-Series model's board, enclosure and vehicle connectors differ. Image: Link Engine Management Vi-PEC product archive, reproduced with permission.

Vi-PEC V Series Mazda RX7 S6-7 is a V Series plug-in ECU documented for Mazda RX-7 Series 6–7. It is a vehicle-specific replacement board, and the precise model year, engine, ECU connector and market variant must be checked against the installation guide. Link's Vi-PEC manual index.

Installation and pin functions

Use the specific Vi-PEC installation manual for this application. Its installation instructions and pin-function sections identify connections and application differences; a similarly named V Series plug-in board for another vehicle must not be used as a wiring reference. Check the original ECU part number and wiring before fitting.

Programming and support

Link lists Vi-PEC Tuning Software (VTS) for the V Series. Firmware compatibility and the calibration depend on the ECU version. Consult the software archive and retain the original calibration before any change.

Identification limits

This page is indexed by the documented application rather than an independently verified manufacturer SKU. Check the manual for exact compatibility and do not infer additional vehicle fitments.

Manufacturer pinout tables

These are all positions listed in the application-specific Vi-PEC installation guide, page 20. The guide specifies the view looking into the ECU from the wire side. Positions omitted by the guide are not assumed unused; functions must be configured for the vehicle. The pinout is labelled RX-7 Series 6 in the manufacturer guide. Confirm any Series 7 application and hardware against Vi-PEC before using it.

Main ECU connector: documented positions

PositionECU function
1Injection 2
74An Volt 3
2Injection 1
75DI 1
3Aux 1
76Aux – Inj 8
5Aux 2
78Ignition 3
7Aux 3
79DI 3
8Aux 5
80DI 4
9Aux 6
83Aux – Inj 6
10Trig 2
86DI 5
11Trig 1
87Aux – Ign 4
14Injection 4
88Ignition 2
15Injection 3
89Ignition 1
21Aux 7
92+14V Main Relay
13Ground
22Aux 8
32Knock 1
35An Volt 1
36An Temp 2
37An Volt 4
38An Volt 2
41An Temp 1
45Aux – Inj 5
52Aux – Inj 7
62Aux 4
71An Temp 3
73DI 2

Other connections

PositionECU function
Expansion 1Signal Ground
Expansion 2+5V Out
Expansion 3DI 6
Expansion 4-
Expansion 5An Volt 5
Expansion 6An Volt 6
Expansion 7-
Expansion 8-

Directly applicable articles

Technical articles assigned to this context will appear here.