Tuning Wiki
Vi-PEC iSupra ECU in an open enclosure
Vi-PEC iSupra i-Series plug-in ECU shown as a family illustration; this V-Series model's board, enclosure and vehicle connectors differ. Image: Link Engine Management Vi-PEC product archive, reproduced with permission.

Vi-PEC V Series Holden VL is a V Series plug-in ECU documented for Holden VL Commodore. It is a vehicle-specific replacement board, and the precise model year, engine, ECU connector and market variant must be checked against the installation guide. Link's Vi-PEC manual index.

Installation and pin functions

Use the specific Vi-PEC installation manual for this application. Its installation instructions and pin-function sections identify connections and application differences; a similarly named V Series plug-in board for another vehicle must not be used as a wiring reference. Check the original ECU part number and wiring before fitting.

Programming and support

Link lists Vi-PEC Tuning Software (VTS) for the V Series. Firmware compatibility and the calibration depend on the ECU version. Consult the software archive and retain the original calibration before any change.

Identification limits

This page is indexed by the documented application rather than an independently verified manufacturer SKU. Check the manual for exact compatibility and do not infer additional vehicle fitments.

Manufacturer pinout tables

All positions listed in the application-specific Vi-PEC installation guide, page 20, appear below. The guide specifies the view looking into the ECU from the wire side. It does not list every factory connector cavity; omitted positions are not assumed unused. The guide identifies the Holden VL RB30 application.

Main ECU connector: documented positions

PositionECU function
101Injector 1
24An Volt 2
102Injector 5
25+5V Out
103Injector 3
35An Volt 5
104Injector 4
29DI 3
105Injector 2
38An Volt 3
106Injector 6
27+14V (Main Relay)
112Ground
30AnTemp2 (For IAT install)
1Aux 1
2Aux 2
5Ign 1
8Trig 1
9DI1
10DI2
11Aux 3
16Aux 4
17Trig 2
18An Volt 1
19Aux 5
21Knock 1
22DI 4
23An Temp 1

Other connections

PositionECU function
Internal MAPAn Volt 3
Expansion 1Signal Ground
Expansion 2+5V Out
Expansion 3DI 5
Expansion 4DI 6
Expansion 5An Volt 5
Expansion 6An Volt 6
Expansion 7An Temp 2
Expansion 8An Temp 3

Directly applicable articles

Technical articles assigned to this context will appear here.