Tuning Wiki

Haltech IG5: IG5 is a historical programmable ignition controller, listed in Haltech's discontinued manual and software archives. The IG5 manual describes ignition outputs used to trigger an igniter; it does not establish a complete fuel-injection ECU. Manufacturer information.

Identification and connection

Record ECU model, serial, hardware revision, firmware and loom part number before choosing wiring. Select the IG5 manual in the manufacturer's archive. Its documented ignition signals require a suitable igniter, with output configuration matched to its type; the outputs must not be treated as direct coil drivers. Model-specific manual or diagram.

Software and related models

Use the manufacturer's model-appropriate software and documentation. Configuration and available outputs depend on exact hardware and the intended installation. See the manufacturer model index for related systems.

Manufacturer main connector schedule

The 20-way J1 positions are transcribed from Haltech’s IG5 main harness electrical diagram, revision B, dated 15 December 1998. The source labels both pins 1 and 14 “AUX OUT3”, while its separate ignition breakout also lists AUX OUT1; that discrepancy is unresolved. Confirm the exact loom and pin functions with Haltech before wiring. Wire-colour fields in the diagram appear repeated and are not reproduced here as authoritative.

J1 pinFunction shown on diagram
1Aux output 3
2Tachometer
3Bypass
4Aux input
5TX
6ECU +13 V DC
7Coolant temperature
8Home
9Trigger
10Throttle position
11Aux output 4
12Ignition output
13Aux output 2
14Aux output 3
15RX
16Ground
17+5 V DC
18Air temperature
19Trim
20MAP

J3 nine-way PC interface

PinFunction
2TX
3RX
5Ground

Other PC interface positions are not shown in the diagram.

Directly applicable articles

Technical articles assigned to this context will appear here.

Shared family guidance

From parent families. Broader context does not establish compatibility with this ECU or software version.