
ME100 GEN-X is a programmable ignition-only controller. ME lists four-, six- and eight-cylinder wasted-spark applications and variable-valve-timing control; the older revision 1.3 manual describes a four-cylinder configuration, so check the actual hardware, firmware and exact harness before assuming the same capabilities or pins. Manufacturer documentation · ME manuals and downloads.
Identification and configuration
Record the complete model label, serial number, hardware generation, firmware and harness. Wire-in ECUs and vehicle-specific plug-in versions have different physical connections. Software and output assignments depend on the unit and calibration; follow the appropriate manufacturer wiring guide and check the installed configuration.
GEN-X 24-way pinout — manual revision 1.3
From NODIZ Pro / ME100 GEN-X manual revision 1.3, section 6.2. The source depicts the plug face and numbers; check the view, exact hardware and equipment-specific notes. It describes the four-cylinder configuration; the current ME100 listing advertises additional cylinder support, which this older table alone does not establish. Do not use it to wire an unverified variant.
| Pin | Documented function |
|---|---|
| A1 | Coil B switched ground |
| A2 | Inlet air temperature |
| A3 | Chassis ground |
| A4 | RS232 transmit |
| A5 | RS232 receive |
| A6 | Sensor / signal ground |
| A7 | TPS / MAP 5 V reference |
| A8 | Coil C; not used in documented four-cylinder configuration |
| B1 | Coil A switched ground |
| B2 | Coolant temperature |
| B3 | Launch control input |
| B4 | Knock positive |
| B5 | Crank sensor positive |
| B6 | Crank sensor negative |
| B7 | Sensor shields / grounds and serial ground |
| B8 | Coil D; not used in documented four-cylinder configuration |
| C1 | Low side 2 |
| C2 | Low side 1 |
| C3 | TPS / MAP signal |
| C4 | Cam VR positive |
| C5 | Cam VR negative |
| C6 | Ignition-switched 12 V |
| C7 | Low side 3 |
| C8 | Tachometer output |
Software and further information
ME provides MEITE / EZ Tune, firmware and installation guides on its support page. Confirm the software and firmware required by the actual unit. See Motorsport Electronics ECU family.
Sources reviewed 17 November 2026.