Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Injectors
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Injector catalogue › Diesel injectors › Diesel injector testing

Diesel injector testing starts with the system design and the fault. Common-rail injectors can be screened on the vehicle and measured on a suitable diesel bench; conventional nozzle holders, cam-driven unit injectors and HEUI need different equipment. This section follows the diagnosis from the vehicle through a documented test and refit.

Common-rail diesel diagnostic pathway: vehicle checks, an approved return-flow test, specialist bench testing, then refitting and verification
Original Tuning Wiki testing-pathway diagram, created for this guide; CC BY 4.0. Use a return-flow test only where the vehicle procedure and equipment support it.

Choose a guide

Understand the difference between checks

A scan tool can show fault codes, rail pressure and cylinder corrections. A compatible return-flow kit measures back-leakage during an approved vehicle test. A specialist common-rail bench can measure individual delivery and return against the applicable test plan. Each answers a different question: acceptable leak-off or a normal electrical reading does not prove correct nozzle delivery.

Match the bench driver, fixture and plan to the complete part number. Some systems, including certain piezo designs, need a pressurised return circuit. Do not use open-bottle arrangements or a solenoid drive on them unless the relevant vehicle and equipment instructions explicitly permit it. Pico's restricted low-return-pressure test and Bosch's piezo return adapter illustrate the distinction.

Safety and service

Diesel high-pressure circuits and some return circuits can retain pressure, and injector drives can use hazardous voltage. Follow the vehicle and bench manufacturer's isolation, cleanliness and guarding instructions. Never loosen a high-pressure pipe on a running engine or feel for a fuel jet. Suspected high-pressure injection into skin requires immediate emergency medical care; see HSENI's safety alert.

Repair and code generation are injector- and programme-specific. Where required, the correct individual compensation code must also be entered into the vehicle ECU for the correct cylinder. The report should say what was tested, what passed or failed, which steps were unavailable, and what work was carried out.

Where this fits in the wiki

For part numbers see the diesel injector catalogue. For system operation see common-rail diesel injectors, common-rail fuel-system tests and Bosch diesel test benches.

Llandow Tuning's published service description describes its use of a separate Delphi bench for supported common-rail diesel injectors. It does not name the bench model on that page and states that VW PD injectors are not supported; check coverage for the specific part.