
Speeduino is an open-source engine-management project with firmware, hardware designs and a community of independent builders and vendors. Official boards, their revisions and third-party implementations are not interchangeable products: establish the board, connector, controller, firmware and build before using a wiring diagram. Its official hardware designs are published under CERN-OHL-S; see the official hardware repository and getting-started manual.
Official board families
- v0.1 — early stationary-test prototype
- v0.2 — early screw-terminal shield
- v0.3 — four-channel screw-terminal shield
- v0.4 — four-channel IDC shield
- Dropbear family: V1 and V2 eight-channel ECUs
- MX-5/Miata NA6 plug-in
Third-party Speeduino-compatible designs
These boards use project firmware but are WTMtronics designs, not official project hardware. Consult the exact manufacturer’s documentation.
Wiring and commissioning
The v0.3 shield uses screw terminals, whereas the v0.4 series uses a 40-pin IDC connection plus a separate 12 V feed. Dropbear has two keyed 24-way connectors. A Mazda NA6 plug-in requires specific original harness and fuel-pump changes. Never substitute one diagram for another. Verify sensor conditioning, injector impedance, output driver type, firmware board selection and fuse arrangements against the exact board documentation before wiring.
See the hardware requirements and board layout configuration.
Country of origin is not asserted here; the project and its independent hardware ecosystem are international.
Guides and software
Browse the Speeduino & standalone tuning section for related guides, software and standalone ECU references.