Tuning Wiki
Applies to

Check the hardware and software limits stated in this article.

Speeduino Dropbear V2
Dropbear V2. Image: WTMtronics; reproduced with permission.

Dropbear is a complete Speeduino project ECU. The original V1 uses Teensy 3.5; the V2 uses Teensy 4.1 and USB-C and is not compatible with Teensy 3.5. The project documents eight high-impedance injector outputs, eight 5/12 V coil pre-drivers, six 2 A auxiliary outputs, onboard VR conditioning, CAN, optional stepper driver and an internal MAP sensor. SD logging requires suitable firmware. V2 wireless equipment depends on the fitted unit; the project guide describes an Airbear socket while WTMtronics' V2 listing describes onboard Wi-Fi and Bluetooth LE.

Connector pinouts

Two keyed Delphi Sicma 24-way connectors. Tables summarise the project manual; check its connector orientation, current limits, switches, and TunerStudio V1/V2 pin-number differences. Ignition outputs are logic pre-drivers, not direct high-current coil outputs. Fan and fuel pump outputs operate relays, not motors directly.

Black connector

PinFunction
A1Switched 12 V
A2Power ground
A35 V sensor reference
A4Not used
A5Spare digital input 2
A6CAN L
A7CAN H
A8Power ground
B1Tachometer
B2Crank primary
B3Crank negative (VR only)
B4Cam primary
B5Cam negative (VR only)
B6Spare digital input 1
B7Clutch input (ground switching)
B8Flex sensor
C1Analog sensor ground
C2Spare analog input 1
C3Spare analog input 2
C4Oxygen sensor input
C5Coolant sensor
C6Intake air sensor
C7Throttle position
C8External MAP input

Grey connector

PinFunction
A1Injector 1
A2Injector 2
A3Injector 3
A4Injector 4
A5Injector 5
A6Injector 6
A7Injector 7
A8Injector 8
B1Ignition 1
B2Ignition 2
B3Ignition 3
B4Ignition 4
B5Ignition 5
B6Ignition 6
B7Ignition 7
B8Ignition 8
C1Boost
C2Fan relay
C3Spare 2 / stepper B2
C4Idle / stepper B1
C5VVT / stepper A1
C6Spare 1 / idle 2 / stepper A2
C7Fuel pump relay
C8Power ground

Do not power offboard devices from sensor reference or analog ground; use documented fusing. External MAP input requires the selector set to external.

Confirm exact assembled revision, modifications, controller and firmware before wiring. Sensor conditioning and compatible drivers matter; see project hardware requirements.