
WTMtronics’ Under Arduino Four Channel design is a third-party Speeduino-compatible board, with an inverted separate Arduino Mega above the surface-mount PCB. The designer lists four injector channels, four ignitor channels, VVT, idle, boost, pump and tachometer outputs, trigger and sensor inputs, onboard MAP and barometric sensors; version C includes stepper idle control. Firmware support for any optional function depends on release and configuration.
Versions and wiring
Consult WTMtronics’ UA4C documentation and revision directories for the exact A, B or C-series board. Connector assignments are specific to board and installation; the official v0.4 IDC diagram is not a substitute. Designer’s model overview.
Harness connector layout
The WTMtronics UA4C connections sheet illustrates these physical rows with the USB socket between the two connectors. Positions below are counted left to right solely to reproduce that photo: they are not cavity numbers printed on a connector housing. Refer to the original photo for viewing orientation and check the exact A/B/C board revision and wiring before use.
Connector left of USB in source photograph
| Position from left in source photo | Upper row | Lower row |
|---|---|---|
| 1 | GPI | GPO |
| 2 | IAT | Spare input 2 |
| 3 | CLT | Spare input 1 |
| 4 | TPS | O2 |
| 5 | RPM2+ | RPM2− |
| 6 | RPM1+ | RPM1− |
| 7 | Flex fuel | Ground |
| 8 | 5 V out | Knock |
| 9 | 12 V in | Launch |
| 10 | Ground | Ground |
| 11 | Ground | Ground |
Connector right of USB in source photograph
| Position from left in source photo | Upper row | Lower row |
|---|---|---|
| 1 | Stepper idle A2 | Stepper idle B2 |
| 2 | Stepper idle B1 | Stepper idle A1 |
| 3 | Ignition 4 | Ignition 2 |
| 4 | Ignition 3 | Ignition 1 |
| 5 | VVT | Low-current output 4 |
| 6 | Boost | Low-current output 3 |
| 7 | Idle 2 | Low-current output 2 |
| 8 | Idle 1 | Low-current output 1 |
| 9 | Injector 4 | Fan 2 |
| 10 | Injector 3 | Fan 1 |
| 11 | Injector 2 | Tachometer |
| 12 | Injector 1 | Fuel pump |
The manufacturer's UA4C product information notes that stepper control is built in on C-series boards and that harness connector hardware changed; match the actual board and connector before wiring.