Tuning Wiki
Applies to

Check the hardware and software limits stated in this article.

Speeduino v0.4 board layout
v0.4 board layout. Image: Speeduino project, reproduced with permission.

The v0.4 project board uses four injector channels, four ignition outputs, a 40-pin IDC I/O connector and a separate 12 V feed. It includes provision for an optional DRV8825 stepper idle driver, MAP sensor and VR conditioner. It was developed for a different integration approach from the screw-terminal v0.3.

40-pin IDC connections

Project v0.4 manual: confirm connector orientation, PCB revision, populated options and any modification. The 12 V supply is separate. Prototype pins 14–18 have the documented default assignments only from v0.4.4b onward and require matching configuration.

PinFunction
1Injector 1 (1/2)
2Injector 2 (1/2)
3Injector 3 (1/2)
4Injector 3 (2/2)
5Injector 4 (1/2)
6Injector 4 (2/2)
7Ignition 1
8Ignition 4
9Ground
10Ground
11MAP 0–5 V
12Ground
135 V
14Proto 1 (0.4.4b+ flex)
15Proto 2 (0.4.4b+ fan)
16Proto 3 (0.4.4b+ fuel pump)
17Proto 4 (0.4.4b+ tachometer)
18Proto 5 (0.4.4b+ clutch)
19Coolant
20Intake air temperature
21Oxygen sensor
22Throttle position
23Ground
24Cam / VR2+
25Crank / VR1+
26VR2−
27VR1−
285 V
29Stepper 2B
30Stepper 2A
31Stepper 1A
32Stepper 1B
33Ignition 3
34Ignition 2
35Boost
36Idle 2
37PWM idle
38VVT
39Injector 2 (2/2)
40Injector 1 (2/2)

On versions 0.4.3c and earlier, component orientation differs from 0.4.3d and later; follow the exact revision’s assembly notes. Official revision files.

Confirm exact assembled revision, modifications, controller and firmware before wiring. Sensor conditioning and compatible drivers matter; see project hardware requirements.