Factory control and logged pressure
Scope: These are EA888 Simos 18 examples, mainly 18.1. Exact ECU hardware, engine, transmission, software, calibration and patches determine whether a function or definition applies. Community labels are research leads: confirm the target A2L, axes, units, scaling, selectors and logs. Neither listed names nor file ranges are recommended settings.
Boost control follows an air and torque request, while compressor and turbine models and feedback participate in control and protection. Simos Wiki describes pressure upstream of the throttle (PUT), manifold pressure and electronic wastegate position in its EA888 example. Confirm the installed actuator and sensors: other hardware or a patch can change the path.
Names in a community definition
The bri3d a2l2xdf community definition list labels ip_fac_bpa_sp[0] and ip_fac_bpa_sp[1] wastegate position feedforward VVL 0/1. The SC8S5031 community cross-reference describes a boost-pressure actuator setpoint with factor inputs and an adaptive correction. Community XDF index labels can differ from the A2L entry; verify the active selector and axes, rather than assuming every file uses the same array index.
ip_put_sp is a pressure-upstream-throttle setpoint label in that community family. A particular SC8S5031 reference lists rpm and manifold pressure setpoint as its axes. ip_ad_fac_bpa_sp is described as an adaptive correction in the community adaptation reference; this is not a generic new base table to copy.
Two patches, different behaviour
The VehiCAL boost patch says it changes the ip_fac_bpa pre-control axes from intake/exhaust factors to rpm and boost setpoint while retaining PID feedback. Its axes and table must be calibrated for the application.
Separately, the simos.app Easy Wastegate guide documents Wastegate Position Feedforward VVL 0 and Wastegate Position Feedforward VVL 1 maps with rpm and requested-boost axes, in a different control approach. Do not assume VehiCAL's PID description applies to Easy Wastegate or vice versa. The supplier's axis description needs checking against the installed version and logger, especially absolute versus relative pressure.
On changed hardware, stock-model turbo-speed and compressor-temperature estimates can be misleading. Changing associated limits without an alternative means of protecting the actual hardware can remove protection; keep physical limits and measurement in view.
Diagnose before adjusting
Compare the corresponding pressure target/actual, wastegate setpoint and measured position, rpm, valve-lift state, throttle, actuator limits, adaptations and interventions. Check for a mechanical restriction or leak and verify the sensor range. In a turbo-swap thread, copying another calibration's maps did not by itself solve the reported behaviour; the cause remained uncertain.
Related guides: bigger turbos · wastegate and boost control · fuel-system and MPI upgrades · ethanol and flex fuel · torque model and DSG · ignition and knock · launch control · rolling anti-lag.
References reviewed 17 November 2026. Forum accounts are reported observations, not independently verified fixes.