Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Emissions control
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

What the filter is

A diesel particulate filter is a wall-flow trap in the exhaust. The brick is a honeycomb of small channels. Half of them are plugged at the inlet face and half at the outlet face, in a checkerboard. Exhaust enters an open inlet channel, has nowhere to go at the far end, and is forced through the porous wall into a neighbouring outlet channel. The gas leaves. The soot stays on the wall and in the pores.

That is the whole job of the hardware. Burning the soot back off is regeneration, and it is a control-system job described on DPF regeneration. The solid residue that will not burn is ash. The control unit’s estimate of how full the brick is, which is not the same thing as the pressure reading, is the load model.

A petrol particulate filter on a direct-injection engine is the same wall-flow idea in a hotter exhaust. This section is the diesel filter. Sensor faults, aborted cycles and the warning lamp are on particulate filter faults. Why the soot is formed in the first place is on petrol and diesel emissions.

The pages

  • Substrates and coatings: cordierite, silicon carbide, aluminium titanate, metal structures, and the washcoat that makes soot burn at a lower temperature.
  • PAT fluid and fuel-borne catalysts: the additive metered into the diesel on Peugeot, Citroën and related engines, the Eolys generations, and why they must not be mixed.
  • Soot and ash: what burns in a regeneration and what is left in the channels afterwards.
  • Load models: pressure-only, soot-only, and separate ash and soot. Some calibrations leave ash monitoring switched off.
  • Regeneration: passive oxidation, an active burn the control unit starts, and a workshop regeneration.
  • Cleaning: how ash is actually taken out of a brick, and what a bottled cleaner does not do.

What sits around the brick

The can is a steel shell with mats that hold the brick and take up expansion. Upstream there is usually an oxidation catalyst, either in its own can or coated on the front of the filter. That catalyst turns some of the nitric oxide in the exhaust into nitrogen dioxide, and it lights any fuel that a regeneration has added. Temperature sensors sit ahead of the filter and often behind it. A pressure sensor reads the drop across the brick, either as one differential sensor or as two absolute sensors subtracted in the control unit. The hoses on that sensor are part of the measurement. A hose full of water or soot reports a filter that is not the filter on the car.

Engines that use a fuel-borne catalyst have a second tank, or a pouch, and a dosing pump that puts a measured quantity of additive into the fuel when the tank is filled. That circuit is separate from AdBlue. AdBlue is injected into the exhaust for the NOx catalyst, described on selective catalytic reduction. PAT fluid goes into the diesel.

A full filter is two different problems

Soot is carbon. A completed regeneration oxidises it and the pressure drop falls. Ash is the incombustible remainder from the oil, from worn metal, and from the fuel-borne catalyst itself. It packs at the closed ends of the inlet channels, steals volume, and leaves a pressure drop that a regeneration cannot remove. A control unit that models only soot will eventually treat that leftover pressure as soot, and it will try to burn something that is not there. A control unit that models ash separately will keep regenerating for soot and will call for a clean or a new filter when the ash mass, or the pressure that remains after a good burn, reaches its limit.